Nissan Altima Owners Manual: Seat belt maintenance

● To clean the seat belt webbing

, apply a mild soap solution or any solution recommended for cleaning upholstery or carpet.

Then wipe with a cloth and allow the seat belts to dry in the shade. Do not allow the seat belts to retract until they are completely dry.

If dirt builds up in the shoulder belt guide

of the seat belt anchors, the seat belts may retract slowly. Wipe the shoulder belt guide with a clean, dry cloth.

Periodically check to see that the seat belt and the metal components

such as buckles, tongues, retractors, flexible wires and anchors, work properly. If loose parts, deterioration, cuts or other damage on the webbing is found, the entire seat belt assembly should be replaced.

    Seat belt extenders
    If, because of body size or driving position, it is not possible to properly fit the lap/shoulder belt and fasten it, an extender that is compatible with the installed seat belts is available that ...

    Child safety
    WARNING Do not allow children to play with the seat belts. Most seating positions are equipped with Automatic Locking Retractor (ALR) mode seat belts. If the seat belt becomes wrapped around a ch ...

    Other materials:

    Diagnosis and repair workflow
    Work Flow OVERALL SEQUENCE DETAILED FLOW 1. GET INFORMATION FOR SYMPTOM Get the detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred). >> GO TO 2 2. CHECK DTC 1. Check DTC. 2. Perform the following p ...

    Antenna AMP
    Removal and Installation - Coupe REMOVAL 1. Remove the rear pillar finisher RH. Refer to INT-20, "Exploded View". 2. Detach the antenna amp harness clip (B), disconnect the antenna amp connectors (A), remove the antenna amp screw (C) and remove the antenna amp (1). INSTALLATION ...

    Rear-facing child restraint installation using LATCH
    Refer to all Warnings and Cautions in the Child Safety and Child Restraint sections before installing a child restraint. Follow these steps to install a rear-facing child restraint using the LATCH system: 1. Position the child restraint on the seat. Always follow the child restraint manu ...