Nissan Altima 2007-2012 Service Manual: Service data and specifications (SDS)

SERVICE DATA AND SPECIFICATIONS (SDS)

General Specification

Drive Belt


Drive Belt

Spark Plug


Spark Plug

Intake Manifold


Intake Manifold

Exhaust Manifold


Exhaust Manifold

Camshaft


Camshaft


VALVE LIFTER


VALVE LIFTER

VALVE CLEARANCE


VALVE CLEARANCE

AVAILABLE VALVE LIFTER


AVAILABLE VALVE LIFTER


Cylinder Head


Cylinder Head

VALVE DIMENSIONS


VALVE DIMENSIONS

VALVE OIL SEAL


VALVE OIL SEAL

VALVE GUIDE


VALVE GUIDE


VALVE SEAT


VALVE SEAT


VALVE SPRING


VALVE SPRING

Cylinder Block


Cylinder Block


AVAILABLE PISTON


AVAILABLE PISTON

PISTON RING


PISTON RING


PISTON PIN


PISTON PIN

CONNECTING ROD


CONNECTING ROD

CRANKSHAFT


CRANKSHAFT

Main Bearing


Main Bearing

UNDERSIZE


UNDERSIZE

MAIN BEARING OIL CLEARANCE


MAIN BEARING OIL CLEARANCE

Connecting Rod Bearing


Connecting Rod Bearing

UNDERSIZE


UNDERSIZE

CONNECTING ROD BEARING OIL CLEARANCE


CONNECTING ROD BEARING OIL CLEARANCE

Drive Plate


Drive Plate

Flywheel


Flywheel

Engine lubrication system QR25DE


    Disassembly and assembly
    CYLINDER BLOCK Disassembly and Assembly 1. Drive plate reinforcement (CVT) 2. Drive plate (CVT), Flywheel (M/T) 3. Rear oil seal retainer 4. Knock sensor upper main bearing 5. Cylinder block ...

    Other materials:

    P0605 ECM
    Description The ECM consists of a microcomputer and connectors for signal input and output and for power supply. The ECM controls the engine. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always tur ...

    Air conditioning cut control
    System Diagram System Description INPUT/OUTPUT SIGNAL CHART *1: This signal is sent to the ECM via the CAN communication line. *2: ECM determines the start signal status by the signals of engine speed and battery voltage. SYSTEM DESCRIPTION This system improves engine operation when t ...

    Front passenger air bag module
    Removal and Installation REMOVAL CAUTION: • Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least three minutes. • Do not use air tools or electric tools for servicing. • Always work from the side of air bag module. Do not work fro ...