Nissan Altima 2007-2012 Service Manual: IPDM E/R (Intelligent power distribution module engine room)
Diagnosis Procedure
1. CHECK FUSES AND FUSIBLE LINK
Check that the following IPDM E/R fuses or fusible link are not blown.
Is the fuse blown? YES >> Replace the blown fuse or fusible link after repairing the affected circuit.
NO >> GO TO 2
2. CHECK POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect IPDM E/R connectors.
3. Check voltage between IPDM E/R harness connector and ground.
Is the measurement value normal? YES >> GO TO 3
NO >> Repair harness or connector.
3. CHECK GROUND CIRCUIT
Check continuity between IPDM E/R harness connectors and ground.
Does continuity exist? YES >> Inspection End.
NO >> Repair harness or connector.
BCM (Body control module)
Diagnosis Procedure 1. CHECK FUSE AND FUSIBLE LINK Check if the following BCM fuse or fusible link are blown. Is the fuse or fusible link blown? YES >> Replace the blown fuse or fusible l ...Fuel level sensor signal circuit
Description The fuel level sensor unit and fuel pump detects the approximate fuel level in the fuel tank and transmits the fuel level signal to the combination meter. Component Function Check 1 ...Other materials:
Disassembly and assembly
FRONT DRIVE SHAFT
Disassembly and Assembly (Left Side)
1. Circlip
2. Dust shield
3. Slide joint housing
4. Snap ring
5. Spider assembly
6. Stopper ring
7. Boot band
8. Boot
9. Shaft
10. Damper band
11. Damper
12. Boot band
13. Boot
14. Ball cage / Steel ball / Inner race assembly
...
Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
1. GET INFORMATION FOR SYMPTOM
Get the detailed information from the customer about the symptom (the
condition and the environment when
the incident/malfunction occurred).
>> GO TO 2
2. CHECK DTC
1. Check DT ...
Heater core
Removal and Installation
COMPONENTS
1. Heater grommet
2. Heater pipe support
3. Heater and cooling unit foot duct LH
4. Heater core
5. Heater and cooling unit case
REMOVAL
1. Remove the heater and cooling unit assembly. Refer to VTL-12, "Removal and
Installation".
2. Remov ...