Nissan Altima 2007-2012 Service Manual: Electrical units location
ENGINE COMPARTMENT
PASSENGER COMPARTMENT
LUGGAGE COMPARTMENT
Ground
Ground Distribution MAIN HARNESS ENGINE ROOM HARNESS FRONT END MODULE HARNESS ENGINE CONTROL HARNESS BODY HARNESS BODY NO. 2 HARNESS HARNESS Harness Layout HOW TO READ HARNE ...Harness connector
Description HARNESS CONNECTOR (TAB-LOCKING TYPE) • The tab-locking type connectors help prevent accidental looseness or disconnection. • The tab-locking type connectors are disconnected by ...Other materials:
M&A branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the combination meter for damage, bend
and loose connection
(unit side and connector side).
...
Front fog lamp circuit
Description
The IPDM E/R (intelligent power distribution module engine room) controls the
front fog lamp relay based on
inputs from the BCM over the CAN communication lines. When the front fog lamp
relay is energized, power
flows from the front fog lamp relay in the IPDM E/R to the front fog ...
Rear bumper
Removal and Installation
1. Rear bumper side brackets
2. Rear bumper supports
3. Rear bumper reinforcement
4. Rear energy absorbing foam
5. Rear bumper fascia
A. C205 push pin
REMOVAL
1. Remove the LH and RH rear combination lamps. Refer to EXL-260, "Removal
and Installation" ...