Nissan Altima (L32) 2007-2012 Service Manual: Combination meter
Diagnosis Procedure
1.CHECK FUSES
Check for blown combination meter fuses.
Is the inspection result normal? YES >> GO TO 2
NO >> If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse.
2.POWER SUPPLY CIRCUIT CHECK
1. Disconnect combination meter connector.
2. Check voltage between combination meter harness connector M24 terminals 1, 2, 14 and ground.
Is the inspection result normal? YES >> GO TO 3
NO >> Check harness for open between combination meter and fuse.
3.GROUND CIRCUIT CHECK
1. Turn ignition switch OFF.
2. Check continuity between combination meter harness connector terminals 3, 4, 23 and ground.
Is the inspection result normal? YES >> Inspection End.
NO >> Check ground harness.
BCM (Body control module)
Diagnosis Procedure 1. CHECK FUSE AND FUSIBLE LINK Check if the following BCM fuse or fusible link are blown. Is the fuse or fusible link blown? YES >> Replace the blown fuse or fusible l ...Other materials:
Parking brake shoe
Exploded View
1. Return spring
2. Adjuster
3. Brake shoe
4. Anti-rattle pin
5. Retainer
6. Anti-rattle spring
7. Toggle lever
PBC (Poly Butyl Cuprysil) grease
or silicone-based grease
Removal and Installation
WARNING:
• Clean brakes with a vacuum dust collector to minimize the haza ...
Bose speaker AMP
Removal and Installation - Coupe
REMOVAL
1. Disconnect the negative battery terminal.
2. Remove the trunk floor carpet and spare tire cover. Refer to INT-23, "Removal
and Installation".
3. Remove the RH trunk floor spacer.
4. Remove the Bose speaker amp. screws (A), then disc ...
Additional service when replacing
control unit
Description
When replacing ECM, this procedure must be performed.
Special Repair Requirement
1.PERFORM INITIALIZATION OF NATS SYSTEM AND REGISTRATION OF ALL NATS
IGNITION KEY IDS
Refer to EC-563, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special
Repair Requirement&qu ...