Nissan Altima (L32) 2007-2012 Service Manual: DTC U1000 can communication
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
Symptom: Displays “CAN COMM CIRC [U1000]” as a self-diagnosis result of combination meter.
1.CHECK CAN COMMUNICATION
Select “SELF-DIAG RESULTS” mode for “METER/M&A” with CONSULT-III.
>> Go to “LAN system”. Refer to LAN-10, "Condition of Error Detection".
DTC B2205 Vehicle speed circuit
Description The ABS actuator and electric unit (control unit) provides a vehicle speed signal to the combination meter via CAN communication lines. DTC Logic Diagnosis Procedure Symptom: Disp ...Other materials:
BCM (Body control module)
Reference Value
VALUES ON THE DIAGNOSIS TOOL
Terminal Layout
Physical Values
1: Sedan only
2: With LH front window anti-pinch
3: With LH and RH front window anti-pinch
4: With Intelligent Key
5: Without Intelligent Key
Wiring Diagram - ENGIN ...
C1712 - C1715, C1720 - C1723, C1724 -C1727 Transmitter malfunction
Description
One or more transmitters are malfunctioning internally.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.DRIVE VEHICLE
1. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive
the vehicle at any speed for
10 minutes.
2. Check all tire pressu ...
B2608 starter relay
Description
Located in IPDM E/R, it runs the starter motor. The starter relay is turned
ON by the BCM when the ignition
switch is in START position. IPDM E/R transmits the starter relay ON signal to
BCM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2608 is displaye ...