Nissan Altima 2007-2012 Service Manual: Door switch
Description
Detects door open/close condition and transmits the signal to BCM.
Component Function Check
1. CHECK FRONT DOOR SWITCH INPUT SIGNAL
Check (“DOOR SW-DR” and “DOOR SW-AS”) in “DATA MONITOR” mode with CONSULT-III. Refer to BCS- 34, "RETAINED PWR : CONSULT-III Function (BCM - RETAINED PWR)".
Is the inspection result normal? YES >> Front door switch circuit is OK.
NO >> Refer to PWC-326, "Diagnosis Procedure".
Diagnosis Procedure
1. CHECK HARNESS CONTINUITY
Check voltage between BCM connector and ground.
Is the measurement value within the specification? YES >> Replace BCM. Refer to BCS-96, "Removal and Installation".
NO >> GO TO 2
2. CHECK HARNESS CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect BCM and front door switch.
3. Check continuity between BCM connector (A) and front door switch connector (B).
4. Check continuity between BCM connector (A) and ground.
Is the inspection result normal? YES >> GO TO 3
NO >> Repair or replace harness.
3. CHECK BCM OUTPUT SIGNAL
1. Connect BCM connector.
2. Check voltage between BCM connector and ground.
Is the measurement value within the specification? YES >> GO TO 4
NO >> Replace BCM. Refer to BCS-96, "Removal and Installation".
4. CHECK FRONT DOOR SWITCH
Check front door switch.
Refer to PWC-327, "Component Inspection".
Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
NO >> Replace front door switch.
Component Inspection
1. CHECK FRONT DOOR SWITCH
Check front door switches.
Is the inspection result normal? YES >> Front door switch is OK.
NO >> Replace front door switch.
Passenger side
Description Detects condition of the front power window motor RH operation and transmits to power window and door lock/unlock switch RH as pulse signal. Component Function Check 1.CHECK ENCODER ...Door key cylinder switch
Description Power window main switch detects condition of the door key cylinder and transmits to BCM as the LOCK or UNLOCK signals. Component Function Check 1. CHECK DOOR KEY CYLINDER SWITCH IN ...Other materials:
Normal operating condition
Description
The majority of the audio concerns are the result of outside causes (bad CD,
electromagnetic interference,
etc.).
NOISE
The following noise results from variations in field strength, such as fading
noise and multi-path noise, or
external noise from trains and other sources. It i ...
B260D steering lock unit
Description
The electronic steering column lock performs the check by itself according to
the steering lock status (before
lock, after lock and unlock).
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON.
2. Turn ig ...
P0130, P0150 A/F sensor 1
Description
The air fuel ratio (A/F) sensor 1 is a planar one-cell limit current sensor.
The sensor element of the A/F sensor 1 is composed an electrode
layer, which transports ions. It has a heater in the element.
The sensor is capable of precise measurement = 1, but also in the
lean and ...