Nissan Altima 2007-2012 Service Manual: TCM branch line circuit

Diagnosis Procedure

INSPECTION PROCEDURE

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side).

- TCM

- Harness connector F1

- Harness connector E3

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.CHECK HARNESS FOR OPEN CIRCUIT

1. Disconnect the connector of TCM.

2. Check the resistance between the TCM harness connector terminals.

Is the measurement value within the specification?


Is the measurement value within the specification? YES >> GO TO 3.

NO >> Repair the TCM branch line.

3.CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the TCM. Refer to the following.

• QR25DE models: TM-380, "Wiring Diagram - CVT CONTROL SYSTEM - Coupe" or TM-389, "Wiring Diagram - CVT CONTROL SYSTEM - Sedan" • VQ35DE models: TM-202, "Wiring Diagram—CVT CONTROL SYSTEM—Coupe" or TM-211, "Wiring Diagram— CVT CONTROL SYSTEM—Sedan" Is the inspection result normal? YES (Present error)>>Replace the TCM. Refer to the following.

• QR25DE models: TM-430, "Exploded View" • VQ35DE models: TM-254, "Exploded View" YES (Past error)>>Error was detected in the TCM branch line.

NO >> Repair the power supply and the ground circuit.

    ABS branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

    IPDM-E branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

    Other materials:

    P1574 ASCD Vehicle speed sensor
    Description The ECM receives two vehicle speed signals via the CAN communication line. One is sent from combination meter, and the other is from TCM (Transmission control module). The ECM uses these signals for ASCD control. Refer to EC-1090, "System Diagram" for ASCD functions. ...

    P1572 ASCD brake switch
    Description When the brake pedal is depressed, ASCD brake switch is turned OFF and stop lamp switch is turned ON. ECM detects the state of the brake pedal by this input of two kinds (ON/OFF signal). Refer to EC-67, "System Description" for the ASCD function. DTC Logic DTC DET ...

    Rear window defogger and door mirror defogger do not operate
    Diagnosis Procedure 1. CHECK REAR WINDOW DEFOGGER SWITCH Check rear window defogger switch. Refer to DEF-13, "Component Function Check". Is the inspection result normal? YES >> GO TO 2 NO >> Repair or replace the malfunctioning parts. 2. CHECK REAR WINDOW DEFOGGER R ...