Nissan Altima 2007-2012 Service Manual: Fender protector
Removal and Installation
1. Fender protector
2. Fender protector side cover
A. J-clips
B. Clips
C. Center mudguard screw
a. Sheet metal nut
REMOVAL
1. Remove the engine under cover. Refer to EXT-34, "Removal and Installation".
2. Remove the screw from center mudguard.
3. Remove the fender protector screws and clips.
4. Remove the fender protector.
INSTALLATION
Installation is in the reverse order of removal.
Cowl top
Removal and Installation 1. Cowl top seal 2. Cowl top side trim covers 3. Cowl top foam blocks 4. Cowl top A Clips REMOVAL 1. Remove both the RH and LH wiper arms. Refer to WW-116, "FRON ...Mudguard
Removal and Installation REMOVAL 1. Remove the C205 push-pins located on the under body. 2. Remove the center mudguard screws and remove the center mudguard. INSTALLATION Installation is in ...Other materials:
P0031, P0032 A/F sensor 1 heater
Description
SYSTEM DESCRIPTION
The ECM performs ON/OFF duty control of the A/F sensor 1 heater corresponding
to the engine operating
condition to keep the temperature of A/F sensor 1 element at the specified
range.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITI ...
C1716 - C1719 Transmitter pressure malfunction
Description
Air pressure data from one or more transmitters is out of range.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.ID REGISTRATION AND VEHICLE DRIVING
1. Carry out ID registration of all transmitters.
2. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and ...
Precaution
HANDLING PRECAUTIONS FOR PLASTICS
Precautions For Plastics
1. When repairing and painting a portion of the body adjacent to plastic
parts, consider their characteristics
(influence of heat and solvent) and remove them if necessary or take suitable
measures to protect them.
2. Plastic par ...