Nissan Altima 2007-2012 Service Manual: Normal operating condition
Description
The majority of the audio concerns are the result of outside causes (bad CD, electromagnetic interference, etc.).
NOISE
The following noise results from variations in field strength, such as fading noise and multi-path noise, or external noise from trains and other sources. It is not a malfunction.
• Fading noise: This noise occurs because of variations in the field strength in a narrow range due to mountains or buildings blocking the signal.
• Multi-path noise: This noise results from the waves sent directly from the broadcast station arriving at the antenna at a different time from the waves which reflect off mountains or buildings.
The vehicle itself can be a source of noise if noise prevention parts or electrical equipment is malfunctioning.
Check if noise is caused and/or changed by engine speed, ignition switch turned to each position, and operation of each piece of electrical equipment, and determine the cause.
NOTE: The source of the noise can be found easily by listening to the noise while removing the fuses of electrical components, one by one.
Type of Noise and Possible Cause
Satellite radio tuner
Symptom Table ...Precaution
Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used alon ...Other materials:
Mechanical system
Cross-Sectional View
1. Converter housing
2. Oil pump
3. Forward clutch
4. Reverse brake
5. Planetary carrier
6. Primary pulley
7. Steel belt
8. Sun gear
9. Side cover
10. Internal gear
11. Secondary pulley
12. Final gear
13. Differential case
14. Idler gear
15. Reduction gear
16. ...
Oil cooler
Removal and Installation
1. Oil filter
2. Oil cooler bolt
3. Water pipe
4. Water hose
5. Oil cooler
6. O-ring
7. Oil pan
8. Water pipe
9. Relief valve
10. Water drain plug
11. Copper gasket
12. Water connector
WARNING:
Be careful not to get burned, engine coolant and engine oil may ...
Diagnosis and repair work flow
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
1.GET INFORMATION FOR SYMPTOM
Get the detailed information from the customer about the symptom (the
condition and the environment when
the incident/malfunction occurred) using the “Diagnostic Work Sheet”. (Refer to
EC-22, "Diagnostic Work
...