Nissan Altima 2007-2012 Service Manual: Accelerator pedal released position learning

 Description

Accelerator Pedal Released Position Learning is a function of ECM to learn the fully released position of the accelerator pedal by monitoring the accelerator pedal position sensor output signal. It must be performed each time the harness connector of the accelerator pedal position sensor or ECM is disconnected.

Special Repair Requirement

1.START

1. Check that accelerator pedal is fully released.

2. Turn ignition switch ON and wait at least 2 seconds.

3. Turn ignition switch OFF and wait at least 10 seconds.

4. Turn ignition switch ON and wait at least 2 seconds.

5. Turn ignition switch OFF and wait at least 10 seconds.

>> END

    Vin registration
     Description VIN Registration is an operation to register VIN in ECM. It must be performed each time ECM is replaced. NOTE: Accurate VIN which is registered in ECM may be required for Ins ...

    Throttle valve closed position learning
     Description Throttle Valve Closed Position Learning is a function of ECM to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. I ...

    Other materials:

    Disassembly and assembly
    FRONT DRIVE SHAFT Disassembly and Assembly (Left Side) 1. Circlip 2. Dust shield 3. Slide joint housing 4. Snap ring 5. Spider assembly 6. Stopper ring 7. Boot band 8. Boot 9. Shaft 10. Damper band 11. Damper 12. Boot band 13. Boot 14. Ball cage / Steel ball / Inner race assembly ...

    Control buttons
    The control buttons for the Bluetooth® Hands-Free Phone System are located on the steering wheel. PHONE/SEND Press the button to initiate a VR session or answer an incoming call. You can also use the button to interrupt the system feedback and give a command at once. See “List o ...

    Turn signal and hazard warning lamps
    System Diagram System Description • BCM (Body Control Module) controls turn signal lamp (RH and LH) and hazard warning lamp operation. • Combination meter operates turn (RH and LH) indicator according to CAN communication signals from BCM. Component Parts Location 1. BCM M16, M ...