Nissan Altima 2007-2012 Service Manual: Additional service when replacing control unit

Description

Initial setting is necessary when replacing main power window and door lock/unlock switch. CAUTION: The following specified operations are not performed under the non-initialized condition.

• Auto-up operation

• Anti-pinch function

• Retained power operation

 Special Repair Requirement

INITIALIZATION PROCEDURE

1. Disconnect battery negative terminal or main power window and door lock/unlock switch. Reconnect it after a minute or more.

2. Turn ignition switch ON.

3. Operate power window switch to fully open the window. (This operation is unnecessary if the window is already fully open) 4. Continue pulling the power window switch UP (AUTO-UP operation). Even after glass stops at fully closed position, keep pulling the switch for 4 seconds or more.

5. Inspect anti-pinch function.

CHECK ANTI-PINCH FUNCTION

1. Fully open the door window.

2. Place a piece of wood near fully closed position.

3. Close door glass completely with AUTO-UP.

• Check that glass lowers for approximately 150 mm or 2 seconds without pinching piece of wood and stops.

• Check that glass does not rise when operating the main power window and door lock/unlock switch while lowering.

CAUTION: • Do not check with hands and other part of body because they may be pinched. Do not get pinched.

• Check that AUTO-UP operates before inspection when system initialization is performed.

• It may switch to fail-safe mode if open/close operation is performed continuously. Perform initial setting in that situation. Refer to PWC-42, "Fail Safe".

• Perform initial setting when auto-up operation or anti-pinch function does not operate normally.

• Finish initial setting. Otherwise, next operation cannot be done.

1. Auto-up operation

2. Anti-pinch function

3. Retained power operation when ignition switch is OFF.

    Additional service when removing battery negative terminal
     Description Initial setting is necessary when battery terminal is diconnected. CAUTION: The following specified operations are not performed under the non-initialized condition. • Auto ...

    Other materials:

    Removal and installation
    REAR SUSPENSION ASSEMBL Exploded View 1. Cap 2. Shock absorber insulator 3. Shock absorber seal 4. Bound bumper 5. Shock absorber 6. Suspension arm 7. Connecting rod mount bracket 8. Connecting rod 9. Upper rubber seat 10. Coil spring 11. Lower rubber seat 12. Knuckle 13. Knuckle bus ...

     Front Brake Pad
    Inspection PAD WEAR Check pad thickness from an inspection hole on cylinder body. Check using a scale if necessary. Front Brake Rotor Inspection VISUAL Check surface of disc rotor for uneven wear, cracks, and serious damage. Replace if necessary. RUNOUT 1. Attach the disc rotor to ...

    Cooling fan
    Description The ECM controls the cooling fan corresponding to the vehicle speed, engine colant temperature, refrigerant pressure, and air conditioner ON signal. The control system has 4-step control [HIGH/MIDDLE/LOW/OFF]. COOLING FAN MOTOR The cooling fan operates at each speed when the cur ...