Nissan Altima 2007-2012 Service Manual: Additional service when replacing control unit

Description

When replacing ECM, this procedure must be performed.

Special Repair Requirement

1.PERFORM INITIALIZATION OF NATS SYSTEM AND REGISTRATION OF ALL NATS IGNITION KEY IDS

Refer to SEC-15, "ECM RE-COMMUNICATING FUNCTION : Special Repair Requirement" (Coupe) or SEC- 214, "ECM RE-COMMUNICATING FUNCTION : Special Repair Requirement" (Sedan).

>> GO TO 2.

2.PERFORM VIN REGISTRATION

Refer to EC-29, "VIN REGISTRATION : Special Repair Requirement".

>> GO TO 3.

3.PERFORM ACCELERATOR PEDAL RELEASED POSITION LEARNING

Refer to EC-29, "ACCELERATOR PEDAL RELEASED POSITION LEARNING : Special Repair Requirement".

>> GO TO 4.

4.PERFORM THROTTLE VALVE CLOSED POSITION LEARNING

Refer to EC-29, "THROTTLE VALVE CLOSED POSITION LEARNING : Special Repair Requirement".

>> GO TO 5.

5.PERFORM IDLE AIR VOLUME LEARNING

Refer to EC-30, "IDLE AIR VOLUME LEARNING : Special Repair Requirement".

>> END

    Inspection and adjustment
    BASIC INSPECTION  Special Repair Requirement 1.INSPECTION START 1. Check service records for any recent repairs that may indicate a related malfunction, or a current need for scheduled main ...

    Idle speed
     Description This describes how to check the idle speed. For the actual procedure, follow the instructions in “BASIC INSPECTION”. IDLE SPEED : Special Repair Requirement 1.CHECK IDLE S ...

    Other materials:

    Front wiper ARMS
    Removal and Installation REMOVAL 1. Turn wiper switch ON to operate wiper motor, and then turn wiper switch OFF (auto stop). 2. Open hood, remove arm caps, and remove wiper arm nuts. 3. Raise wiper arm, and remove wiper arm from the vehicle. INSTALLATION 1. Clean up the pivot area as sho ...

    Floor trim
    Exploded View 1. Spacer (RH) 2. Spacer (LH) 3. Floor mat hook 4. Floor carpet 5. Harness clamp Removal and Installation REMOVAL 1. Remove front seat (RH/LH) and rear seat cushion. Refer to SE-51, "Removal and Installation" and SE-53, "Removal and Installation". ...

    P0703 stop lamp switch
    Description BCM detects ON/OFF state of the stop lamp switch and transmits the data to the TCM via CAN communication by converting the data to a signal. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION ...