Nissan Altima 2007-2012 Service Manual: Air cleaner filter
Removal and Installation
1. Air duct hose
2. Air cleaner filter
3. Air cleaner case (front)
4. Front air duct
5. Air cleaner mounting bracket
6. Air cleaner case (rear)
7. Mass air flow sensor
A. To electric throttle control actuator
B. Air cleaner case side clips
CHANGING THE AIR CLEANER FILTER
CAUTION: It is not necessary to remove the front air duct to replace the air cleaner element.
1. Unhook the air cleaner case side clips.
2. Remove the air cleaner filter.
3. Install a new air cleaner filter.
4. Lock the air cleaner case side clips.
Drive belts
Checking Drive Belts
WARNING:
Inspect the drive belt only when the engine is stopped.
• Make sure that the stamp mark of drive belt auto-tensioner is within the
usable range.
NOTE:
• ...
Camshaft valve clearance
Camshaft valve clearance
• Perform this inspection as follows after removal, installation, or
replacement of the camshaft or any valverelated
parts, or if there are any unusual engine conditions ...
Other materials:
B1134 – B1137 side airbag module LH
Description
DTC B1134 – B1137 FRONT LH SIDE AIR BAG MODULE
The front LH side air bag module is wired to the air bag diagnosis sensor
unit. The air bag diagnosis sensor
unit will monitor for opens and shorts in detected lines to the front LH side
air bag module.
PART LOCATION
Refer to SRC- ...
P2119 electric throttle control
actuator
Description
Electric throttle control actuator consists of throttle control motor,
throttle position sensor, etc.
The throttle control motor is operated by the ECM and it opens and closes the
throttle valve.
The throttle position sensor detects the throttle valve position, and the
openi ...
B2560 starter control relay
Description
Starter control relay, integrated in IPDM E/R, permits the starter relay
operation when in N or P position and
the steering is locked or unlocked. It is installed in parallel with the starter
relay.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2560 is displayed with DTC U1 ...