Nissan Altima 2007-2012 Service Manual: Air cleaner filter

Removal and Installation

1. Air duct hose

2. Duct sub-cover

3. Front air duct

4. Air cleaner case (lower)

5. Grommets

6. Air cleaner case mounting bracket

7. Bracket

8. Air cleaner filter

9. Air cleaner case (upper)

10. Mass air flow sensor

A. To electric throttle control actuator

B. Air cleaner case side clips

CHANGING THE AIR CLEANER FILTER

CAUTION: It is not necessary to remove the front air duct to replace the ail cleaner filter.

1. Unhook the air cleaner case side clips.

2. Remove the air cleaner filter.

3. Install a new air cleaner filter.

4. Lock the air cleaner case side clips.

    Drive belts
    Checking Drive Belts 1. Power steering pump 2. Drive belt auto-tensioner 3. Crankshaft 4. Idler pulley 5. A/C compressor pulley 6. Generator pulley 7. Idler pulley 8. Drive belt A. Indicato ...

    Camshaft valve clearance
    Valve Clearance CHECKING • Perform inspection as follows after removal, installation or replacement of camshaft or valve related parts, or if there is unusual engine conditions regarding valve c ...

    Other materials:

    U120D DVD-ROM drive mecha
    Description Refer to AV-240, "System Description". DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK DVD-ROM Check DVD-ROM for dirt, scratches and warpage. Is the DVD-ROM clean and undamaged? YES >> Replace AV control unit. Refer to AV-437, "Removal and Ins ...

    Anti-pinch system does not operate normally (driver side)
    Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-108, "POWER WINDOW MAIN SWITCH : Special Repair Requirement". Is the inspection result normal? YES >> GO TO 2 NO >> Repair or replace the malfunctioning parts. 2. C ...

    License lamp finisher
    Removal and Installation 1. License lamp finisher REMOVAL 1. Remove the trunk lid finisher (if equipped). Refer to INT-22, "Exploded View". 2. Remove the license lamp finisher nuts. 3. Remove license lamp finisher by pulling toward the rear, then disconnect the trunk request ...