Nissan Altima (L32) 2007-2012 Service Manual: Air mix door motor
Removal and Installation
AIR MIX DOOR MOTOR - LH
Removal
1. Remove the instrument lower cover LH. Refer to IP-12, "Removal and Installation".
2. Remove the center console side finisher LH. Refer to IP-12, "Removal and Installation".
3. Remove the heater and cooling unit foot duct LH (2).
4. Remove the tire pressure monitoring system receiver.
5. Disconnect the air mix door motor connector (1).
6. Remove the air mix door motor screws (A) and then remove the air mix door motor LH.
Installation
Installation is in the reverse order of removal.
AIR MIX DOOR MOTOR - RH
Removal
1. Remove the glove box. Refer to IP-12, "Removal and Installation".
2. Remove the heater and cooling unit foot duct LH (2).
3. Disconnect the air mix door motor connector (1).
4. Remove the air mix door motor screws (A) and then remove the air mix door motor RH.
Installation
Installation is in the reverse order of removal.
Mode door motor
Removal and Installation REMOVAL 1. Remove the combination meter. Refer to MWI-176, "Removal and Installation". 2. Remove the BCM (2). Refer to BCS-96, "Removal and Installation ...Evaporator
Removal and Installation COMPONENTS 1. Heater and cooling unit case 2. Evaporator 3. Intake sensor 4. In-cabin microfilter 5. Evaporator cover 6. Heater and cooling unit foot duct RH 7. Blow ...Other materials:
P0128 Thermostat function
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P0128 is displayed with DTC P0300, P0301, P0302, P0303 or P0304, first
perform the trouble
diagnosis for DTC P0300, P0301, P0302, P0303, P0304. Refer to EC-776, "DTC
Logic".
Engine coolant temperature has not risen enough to open the t ...
Blind Spot Warning (BSW)
WARNING
Failure to follow the warnings and instructions
for proper use of the BSW
system could result in serious injury or
death.
The BSW system is not a replacement
for proper driving procedures and is
not designed to prevent contact with
vehicles or objects. When changing
lanes, always use t ...
DTC B2205 Vehicle speed circuit
Description
The ABS actuator and electric unit (control unit) provides a vehicle speed
signal to the combination meter via
CAN communication lines.
DTC Logic
Diagnosis Procedure
Symptom: Displays “VEHICLE SPEED CIRC [B2205]” as a self-diagnosis result of
combination meter.
1.CHECK CO ...