Nissan Altima 2007-2012 Service Manual: Anti-pinch system does not operate normally (driver side)

Diagnosis Procedure

1. PERFORM INITIALIZATION PROCEDURE

Perform initialization procedure.

Refer to PWC-108, "POWER WINDOW MAIN SWITCH : Special Repair Requirement".

Is the inspection result normal? YES >> GO TO 2

NO >> Repair or replace the malfunctioning parts.

2. CHECK DOOR WINDOW SLIDING PART

• A foreign material adheres to window glass or glass run rubber.

• Glass run rubber wear or deformation.

• Sash is tilted too much or not enough.

Is the inspection result normal? YES >> GO TO 3

NO >> Repair or replace the malfunctioning parts.

3. CHECK ENCODER CIRCUIT

Check encoder circuit.

Refer to PWC-103, "POWER WINDOW MAIN SWITCH : Component Function Check".

Is the inspection result normal? YES >> Inspection end.

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Rear rh side power window alone does not operate
    Diagnosis Procedure 1. CHECK REAR POWER WINDOW SWITCH RH Check rear power winodw switch RH. Refer to PWC-110, "REAR POWER WINDOW SWITCH : Component Function Check". Is the inspection ...

    Auto operation does not operate but manual operates normally (driver side)
    Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-108, "POWER WINDOW MAIN SWITCH : Special Repair Requirement". Is the inspectio ...

    Other materials:

    Front tweeter
    Removal and Installation REMOVAL 1. Remove the front pillar finisher. Refer to INT-20, "Removal and Installation" (coupe) and INT-42, "Removal and Installation" (sedan). 2. Remove tweeter speaker grille. Refer to IP-12, "Removal and Installation". 3. Remove ...

    P1550 battery current sensor
    Description The power generation voltage variable control enables fuel consumption to be decreased by reducing the engine load which is caused by the power generation of the generator. The battery current sensor is installed to the battery cable at the negative terminal. The sensor measures ...

    B2556 push-button ignition switch
    Description The switch that changes the power supply position. BCM maintains the power supply position status. BCM changes the power supply position with the operation of the push-button ignition switch. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION ...