Nissan Altima (L32) 2007-2012 Service Manual: Anti-pinch system does not operate normally (driver side)
Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to PWC-295, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special
Repair Requirement".
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace the malfunctioning parts.
2. CHECK DOOR WINDOW SLIDING PART
• A foreign material adheres to window glass or glass run rubber.
• Glass run rubber wear or deformation.
• Sash is tilted too much or not enough.
Is the inspection result normal?
YES >> GO TO 3
NO >> Repair or replace the malfunctioning parts.
3. CHECK ENCODER CIRCUIT
Check encoder circuit.
Refer to PWC-320, "DRIVER SIDE : Component Function Check".
Is the inspection result normal?
YES >> Inspection end.
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Diagnosis Procedure
1. CHECK REAR POWER WINDOW SWITCH RH
Check rear power winodw switch RH.
Refer to PWC-310, "REAR POWER WINDOW SWITCH : Component Function Check".
Is the inspectio ...
Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to PWC-295, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special
Repair Requirement&qu ...
Other materials: BSW system operation
For vehicles with the 7 inch (18 cm) display
Side BSW/RCTA Indicator Light
BSW indicator
The BSW system operates above approximately
20 mph (32 km/h).
If the radar sensors detect a vehicle in the
detection zone, the side BSW/RCTA indicator
light (1) illuminates. If the turn signal is
then acti ...
NISSAN Intelligent Key battery
discharge
If the battery of the NISSAN Intelligent Key
is discharged or environmental conditions
interfere with the Intelligent Key operation,
start the engine according to the following
procedure:
1. Place the shift lever in the P (Park)
position.
2. Firmly apply the foot brake.
3. Touch the ignition switc ...
ProPILOT Assist switches
DISTANCE switch:
Long
Middle
Short
RES+ switch:
Resumes set speed or increases speed
incrementally
CANCEL switch:
Deactivates the ProPILOT Assist system
ProPILOT Assist switch:
Turns the ProPILOT Assist system on or off
SET- switch:
Sets desired cruise speed or reduces
speed i ...