Nissan Altima (L32) 2007-2012 Service Manual: Anti-pinch system does not operate normally (passenger side)
Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to PWC-295, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement".
Is the inspection result normal? YES >> GO TO 2
NO >> Repair or replace the malfunctioning parts.
2. CHECK DOOR WINDOW SLIDING PART
• A foreign material adheres to window glass or glass run rubber.
• Glass run rubber wear or deformation.
• Sash is tilted too much or not enough.
Is the inspection result normal? YES >> GO TO 3
NO >> Repair or replace the malfunctioning parts.
3. CHECK ENCODER CIRCUIT
Check encoder circuit.
Refer to PWC-322, "PASSENGER SIDE : Component Function Check".
Is the inspection result normal? YES >> Inspection end.
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Anti-pinch system does not operate normally (driver side)
Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-295, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement&quo ...Auto operation does not operate but manual operates normally (driver side)
Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-295, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement&qu ...Other materials:
The oil pressure warning lamp does not turn off
Description
The oil pressure warning lamp remains illuminated while the engine is running
(normal oil pressure).
Diagnosis Procedure
1.CHECK OIL PRESSURE WARNING LAMP
Perform IPDM E/R auto active test. Refer to PCS-14, "Diagnosis Description".
Is oil pressure warning lamp illumin ...
Air cleaner filter
Removal and Installation
1. Air duct hose
2. Air cleaner filter
3. Air cleaner case (front)
4. Front air duct
5. Air cleaner mounting bracket
6. Air cleaner case (rear)
7. Mass air flow sensor
A. To electric throttle control actuator
B. Air cleaner case side clips
CHANGING THE AIR CLEANE ...
Main line between DLC and ABS circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose
connection (connector side
and harness side).
- Harness co ...