Nissan Altima 2007-2012 Service Manual: ASCD Indicator

Description

The ASCD operation status is indicated by two indicators, (CRUISE and SET on the information display) on the combination meter.

CRUISE indicator is displayed to indicate that ASCD system is ready for operation when MAIN switch on ASCD steering switch is turned ON.

SET indicator is displayed when the following conditions are met.

• CRUISE indicator is displayed.

• SET/COAST switch on ASCD steering switch is turned ON while vehicle speed is within the range of ASCD setting.

SET indicator is displayed during ASCD control.

Refer to EC-603, "System Description" for the ASCD function.

Component Function Check

1.ASCD INDICATOR FUNCTION

Is the inspection result normal? YES >> INSPECTION END

NO >> Go to EC-948, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK DTC

Check that DTC UXXXX is not displayed.

Is the inspection result normal? YES >> GO TO 2.

NO >> Perform trouble diagnosis for DTC UXXXX.

2.CHECK COMBINATION METER OPERATION

Refer to MWI-38, "CONSULT-III Function (METER/M&A)".

Is the inspection result normal? YES >> GO TO 3.

NO >> Check combination meter circuit. Refer to MWI-5, "METER SYSTEM : System Diagram".

3.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> INSPECTION END

    ASCD Brake switch
    Description When the brake pedal is depressed, ASCD brake switch is turned OFF and stop lamp switch is turned ON. ECM detects the state of the brake pedal by this input of two kinds (ON/OFF s ...

    Cooling fan
    Description The ECM controls the cooling fan corresponding to the vehicle speed, engine colant temperature, refrigerant pressure, and air conditioner ON signal. The control system has 4-step cont ...

    Other materials:

    P0744 a/t tcc s/v function (lock -up)
    Description This malfunction is detected when the torque converter clutch does not lock-up as instructed by the TCM. This is not only caused by electrical malfunction (circuits open or shorted), but also by mechanical malfunction such as control valve sticking, improper solenoid valve operat ...

    P0710 cvt fluid temperature sensor
    Description The CVT fluid temperature sensor detects the CVT fluid temperature and sends a signal to the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, ...

    Vehicle security indicator
    Description • Vehicle security indicator is built in combination meter. • NVIS (Nissan Vehicle Immobilizer System-NATS) and vehicle security system conditions are indicated by blink or illumination of vehicle security indicator. Component Function Check 1.CHECK FUNCTION 1. Perform “ ...