Nissan Altima (L32) 2007-2012 Service Manual: Audio antenna (coupe)
Location of Antenna
1. In-line connectors M87, M501
2. Audio unit harness
3. Audio unit
4. Satellite antenna
5. Audio antenna feeder
6. Satellite radio antenna feeder
7. Window Antenna
8. Antenna amp.
9. Satellite radio tuner
Window Antenna Repair
ELEMENT CHECK
1. Attach probe circuit tester (ohm setting) to antenna terminal on each side.
• When measuring continuity, wrap tin foil around the top of probe. Then, press the foil against the wire with your finger.
2. If an element is broken, no continuity will exist.
3. To locate a break, move probe along element. Tester indication will change abruptly when probe passes the broken point.
REPAIR EQUIPMENT
• Conductive silver composition (DuPont No. 4817 or equivalent)
• Ruler 30 cm (11.8 in) long
• Drawing pen
• Heat gun
• Alcohol
• Cloth
REPAIRING PROCEDURE
1. Wipe broken heat wire and its surrounding area clean with a cloth dampened in alcohol.
2. Apply a small amount of conductive silver composition to tip of drawing pen.
Shake silver composition container before use.
3. Place ruler on glass along broken line. Deposit conductive silver composition on break with drawing pen. Slightly overlap existing heat wire on both sides [preferably 5 mm (0.20 in)] of the break.
4. After repair has been completed, check repaired wire for continuity.
This check should be conducted 10 minutes after silver composition is deposited.
Do not touch repaired area while test is being conducted.
5. Apply a constant stream of hot air directly to the repaired area for approximately 20 minutes with a heat gun. A minimum distance of 3 cm (1.2 in) should be kept between repaired area and hot air outlet.
If a heat gun is not available, let the repaired area dry for 24 hours.
Steering switch
Removal and Installation REMOVAL 1. Remove the driver airbag module. Refer to SR-5, "Removal and Installation". 2. Remove the steering wheel switch assembly screws (A), then remove ...Audio antenna (sedan)
Location of Antenna 1. In-line connectors M87, M501 2. Audio unit harness 3. Audio unit 4. Satellite antenna 5. Audio antenna feeder 6. Satellite radio antenna feeder 7. Window Antenna 8. An ...Other materials:
Disassembly and assembly
CENTER CONSOLE ASSEMBLY
Exploded View
1. M/T finisher
2. CVT finisher
3. Storage bin (if equipped)
4. CD changer console bracket (if
equipped)
5. CD changer bracket LH (if
equipped)
6. CD changer bracket RH (if
equipped)
7. CD changer finisher (if equipped)
8. Console
9. Console scre ...
B2014 chain of strg-immu
Description
BCM performs the ID verification with the steering lock unit to release the
steering. BCM starts the communication
with the steering lock unit when keyfob is carried into the passenger
compartment and the push-button
ignition switch is pressed.
DTC Logic
DTC DETECTION LOGIC
...
Manual control
While using the Voice Recognition system, it is
possible to select menu options by using the
steering wheel controls instead of speaking voice
commands. The manual control mode does not
allow dialing a phone number by digits. The user
may select an entry from the Phonebook or Recent
Calls list ...