Nissan Altima 2007-2012 Service Manual: Auto operation does not operate but manual operates normally (driver side)

Diagnosis Procedure

1. PERFORM INITIALIZATION PROCEDURE

Perform initialization procedure.

Refer to PWC-21, "POWER WINDOW MAIN SWITCH : Special Repair Requirement".

Is the inspection result normal? YES >> GO TO 2

NO >> Repair or replace the malfunctioning parts.

2. CHECK ENCODER

Check encoder.

Refer to PWC-19, "POWER WINDOW MAIN SWITCH : Component Function Check".

Is the inspection result normal? YES >> Inspection End.

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Anti-pinch system does not operate normally (driver side)
    Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-21, "POWER WINDOW MAIN SWITCH : Special Repair Requirement". Is the inspection ...

    Power window retained power operation does not operate properly
    Diagnosis Procedure 1. CHECK DOOR SWITCH Check door switch. Refer to PWC-32, "Component Function Check". Is the inspection result normal? YES >> Inspection End. NO >> ...

    Other materials:

    P0745 line pressure solenoid valve
    Description The pressure control solenoid valve A (line pressure solenoid valve) regulates the oil pump discharge pressure to suit the driving condition in response to a signal sent from the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: If “DTC CONFIRMATION PROCE ...

    Engine control system QR25DE except for california
    Basic inspection DIAGNOSIS AND REPAIR WORK FLOW Work Flow OVERALL SEQUENCE DETAILED FLOW 1.GET INFORMATION FOR SYMPTOM Get the detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred) using the “Diagnostic Work S ...

    Steering switch
    Description When one of the steering wheel audio control switches is pushed, the resistance in the steering switch circuit changes depending on which button is pushed. Diagnosis Procedure 1.CHECK HARNESS 1. Turn ignition switch OFF. 2. Disconnect AV control unit connector M46 and spiral ...