Nissan Altima (L32) 2007-2012 Service Manual: Auto operation does not operate but manual operates normally
(passenger side)
Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to PWC-295, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special
Repair Requirement".
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace the malfunctioning parts.
2. CHECK ENCODER
Check encoder.
Refer to PWC-322, "PASSENGER SIDE : Component Function Check".
Is the inspection result normal?
YES >> Inspection end.
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to PWC-295, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special
Repair Requirement&qu ...
Diagnosis Procedure
1. CHECK FRONT DOOR SWITCH
Check front door switch.
Refer to PWC-326, "Component Function Check".
Is the inspection result normal?
YES >> Inspection end.
...
Other materials: Precautions on SRS
This SRS section contains important information
concerning the following systems:
Driver and front passenger supplemental
front-impact air bag (NISSAN Advanced
Air Bag System)
Front seat-mounted side-impact supplemental
air bag
Rear outboard seat-mounted side-impact
supplemental air bag
Roo ...
Heater operation
Heating
This mode is used to direct heated air to
the foot outlets. Some air also flows from
the defrost outlets and the side vent
outlets.
1. Press thebutton to the off
position
for normal heating.
2. Press theair flow control
button.
3. Turn thefan speed control dial
to
the desired position.
...
MOD system operation
The MOD system will turn on automatically
under the following conditions:
When the shift lever is in the R (Reverse)
position.
When the CAMERA button is pressed to
activate the camera view on the display.
When vehicle speed decreases below approximately
6 mph (10 km/h) and the
camera screen ...