Nissan Altima (L33) 2013-2018 Owners Manual: Automatic door locks
● All doors lock automatically when the vehicle speed reaches 15 MPH (24 km/h).
● All doors unlock automatically when the ignition is placed in the OFF position.
The automatic unlock function can be deactivated or activated. To deactivate or activate the automatic door unlock system, perform the following procedure: 1. Close all doors.
2. Place the ignition switch in the ON position.
3. Within 20 seconds of performing Step 2,
push and hold the power door lock switch to
the 
position (UNLOCK) for more
than
5 seconds.
4. When activated, the hazard indicator will flash twice. When deactivated, the hazard indicator will flash once.
5. The ignition switch must be placed in the OFF and ON position again between each setting change.
When the automatic door unlock system is deactivated, the doors do not unlock when the ignition switch is placed in the OFF position. To unlock the door manually, use the inside lock knob or the power door lock switch (driver’s or front passenger’s side).
NOTE:
The automatic door unlock function can be changed using the Vehicle Settings in the vehicle information display. The “Auto Door Unlock” choices are:
● Off
● IGN OFF
● Shift into P
Locking with power door lock switch
Door lock switch
To lock all the doors without a key, push the door
lock switch (driver’s or front passenger’s side) to
the lock position 1 . When locking the door this
way, be certain not t ...
Child safety rear door
Child safety locks help prevent the rear doors
from being opened accidentally, especially when
small children are in the vehicle.
The child safety lock levers are located on the
edge of the re ...
Other materials:
P1217 Engine over temperature
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC P1217 is displayed with DTC UXXXX, first perform the trouble diagnosis
for DTC UXXXX.
Refer to EC-1179, "DTC Logic".
• If DTC P1217 is displayed with DTC P0607, first perform the trouble diagnosis
for DTC P0607. Refer
to EC-137 ...
B2607 steering lock relay
Description
BCM requests to IPDM E/R to supply power to electronic steering column lock.
IPDM E/R sends status of
steering lock unit back to BCM.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2607 is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to
...
Roof side molding
Removal and Installation
1. Body side outer panel
2. Windshield
2. Windshield
REMOVAL
1. Lift and twist the roof side molding up from the rear edge.
2. Disconnect the roof side molding from the clips, and remove the roof side
molding.
INSTALLATION
Installation is in the reverse or ...
