Nissan Altima (L32) 2007-2012 Service Manual ≻ Lan system can system (type 12) ≻ AV Branch line circuit

Nissan Altima (L32) 2007-2012 Service Manual: AV Branch line circuit

Diagnosis Procedure

INSPECTION PROCEDURE

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the terminals and connectors of the AV control unit for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.CHECK HARNESS FOR OPEN CIRCUIT

1. Disconnect the connector of AV control unit.

2. Check the resistance between the AV control unit harness connector terminals.

Is the measurement value within the specification? YES >> GO TO 3.

NO >> Repair the AV control unit branch line.

3.CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the AV control unit. Refer to AV-315, "AV CONTROL UNIT : Diagnosis Procedure".

Is the inspection result normal? YES (Present error)>>Replace the AV control unit. Refer to AV-437, "Removal and Installation".

YES (Past error)>>Error was detected in the AV control unit branch line.

NO >> Repair the power supply and the ground circuit.

A-BAG branch line circuit

Diagnosis Procedure 1.CHECK AIR BAG DIAGNOSIS SENSOR UNIT Check the air bag diagnosis sensor unit. Refer to SRC-3, "Work Flow". Is the inspection result normal? YES >> Replace t ...

BCM branch line circuit

Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

Other materials:

Jacking up vehicle and replacing the damaged tire (AWD models)
WARNING For AWD vehicles - the TEMPORARY USE ONLY spare tire must be installed to the rear wheels only. If a front tire is punctured, install the original rear tire onto the front wheel, then install the TEMPORARY USE ONLY spare tire on the rear. Failure to do so could cause overheating to the AWD ...

Controls
Fan speed control dial The fan speed control dial turns the fan on and off and controls fan speed. Air flow control buttons The air flow control buttons allow you to select the air flow outlets. - Air flows from center and side vents. - Air flows from center and side vents and foot outlets. - Air ...

LED Daytime Running Lights (DRL) system
The LED DRL automatically illuminate at 100% intensity when the engine is started and the parking brake released. The LED Daytime Running Lights (DRL) operate with the headlight switch in any position. When you turn the headlight switch to the position for full illumination, the LED DRL illuminate ...