Nissan Altima 2007-2012 Service Manual: B1209 – b1210 collision detection
Description
DTC B1209 - B1210 COLLISION DETECTION
The air bag diagnosis sensor unit will set this DTC if it has detected a collision which has resulted in a frontal or side deployment of one or more air bags or pre-tensioners. If this DTC is detected after a SRS repair, the air bag diagnosis sensor unit has not yet been replaced. This DTC can not be erased.
PART LOCATION
Refer to SRC-7, "SRS Component Parts Location".
DTC Logic
DTC DETECTION LOGIC
With CONSULT-lll
DTC CONFIRMATION PROCEDURE (With CONSULT-lll)
1.INSPECTION START
Turn ignition switch ON.
>> GO TO 2.
2.CHECK SELF-DIAG RESULT
Check for the DTC on CONSULT-lll.
Is the DTC detected? YES >> Refer to SRC-57, "Diagnosis Procedure (Component Diagnosis)".
NO >> Inspection End.
Diagnosis Procedure (Component Diagnosis)
Refer to SR-20, "For Frontal Collision" or SR-21, "For Side and Rollover Collision".
B1017 – b1022 occupant classification system
Description DTC B1017 – B1022 OCCUPANT CLASSIFICATION SYSTEM (OCS) The occupant classification system control unit is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensor u ...Ecu diagnosis
DIAGNOSIS SENSOR UNIT Wiring Diagram Trouble Diagnosis with CONSULT-III DIAGNOSTIC CODE CHART NOTE: Follow the procedures in numerical order when repairing malfunctioning pa ...Other materials:
Lifting point
Special Service Tool
The actual shapes of Kent-Moore tools may differ from those of special
service tools illustrated here.
CAUTION:
• Every time the vehicle is lifted up, maintain the complete vehicle curb
condition.
• Since the vehicle's center of gravity changes when removing main ...
Auto operation does not operate
but manual operates normally
(driver side)
Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to PWC-108, "POWER WINDOW MAIN SWITCH : Special Repair Requirement".
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace the malfunctioning parts.
2. ...
Front wiper ARMS
Removal and Installation
REMOVAL
1. Turn wiper switch ON to operate wiper motor, and then turn wiper switch
OFF (auto stop).
2. Open hood, remove arm caps, and remove wiper arm nuts.
3. Raise wiper arm, and remove wiper arm from the vehicle.
INSTALLATION
1. Clean up the pivot area as sho ...