Nissan Altima 2007-2012 Service Manual: B2098 ignition relay on stuck

Description

• IPDM E/R operates the ignition relay when it receives an ignition switch ON signal from BCM via CAN communication.

• Turn the ignition relay OFF by pressing the push-button ignition switch once when the vehicle speed is 4 km/ h (2.5 MPH) or less.

• Turn the ignition relay OFF with the following operation when the vehicle speed is more than 4 km/h (2.5 MPH) or when an abnormal condition occurs in CAN communication from the unified meter (Emergency OFF) - Press and hold the push-button ignition switch for 2 seconds or more.

- Press the push-button ignition switch 3 time within 1.5 seconds.

NOTE: The ignition relay does not turn ON for 3 seconds after emergency OFF even if the push-button ignition switch is pressed.

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure

1. PERFORM SELF DIAGNOSIS

1. Turn the ignition switch ON.

2. Erase “Self Diagnostic Result” of IPDM E/R.

3. Turn ignition switch OFF, and wait for 1 second or more.

4. Turn the ignition switch ON. Check “Self Diagnostic Result” again.

Is “IGN RELAY ON” displayed? YES >> Replace IPDM E/R. Refer to PCS-48, "Removal and Installation".

NO >> Refer to GI-42, "Intermittent Incident".

    U1000 can comm circuit
    Description Refer to LAN-7, "System Description". DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE Diagnosis Procedure 1. PERFORM SELF DIAGNOSTIC 1. Turn ignition switch ON ...

    B2099 ignition relay off stuck
    Description • IPDM E/R operates the ignition relay when it receives an ignition switch ON signal from BCM via CAN communication. • Turn the ignition relay OFF by pressing the push-button ig ...

    Other materials:

    IPDM-E branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the IPDM E/R for damage, bend and loose connection (unit side and connector side). Is the in ...

    Crash zone sensor
    Removal and Installation REMOVAL 1. Crash zone sensor harness connector 2. Crash zone sensor A. Crash zone sensor nuts CAUTION: • Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least three minutes. • Do not use air tools or electric tool ...

    Headlamp (halogen)
    Wiring Diagram - Coupe Wiring Diagram - Sedan ...