Nissan Altima (L32) 2007-2012 Service Manual: B2108 steering lock relay
Description
The steering lock relay ON signal is transmitted to IPDM E/R by BCM via CAN
communication.
IPDM E/R turns the steering lock relay ON and transmits the release of the
steering to BCM.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2108 is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to
SEC-235, "DTC Logic".
• If DTC B2108 is displayed with DTC U1010, first perform the trouble diagnosis
for DTC U1010. Refer to
SEC-236, "DTC Logic".
DTC CONFIRMATION PROCEDURE
DTC CONFIRMATION PROCEDURE
1. Press the push-button ignition switch under the following conditions and
wait for at least 1 second.
- CVT selector lever is in the P position
- Do not depress the brake pedal.
2. Check “Self diagnostic result” with CONSULT-III.
Is DTC detected?
YES >> Refer to SEC-241, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.CHECK FUSE
1. Turn ignition switch OFF.
2. Check 10A fuse (No. 40, located in IPDM E/R).
Is the inspection result normal?
YES >> Replace IPDM E/R. Refer to PCS-48, "Removal and Installation".
NO >> Check the following.
• Harness for open or short between IPDM E/R and battery
• Fuse
Description
BCM performs the ID verification with the steering lock unit to release the
steering. BCM starts the communication
with the steering lock unit when Intelligent Key is carried into the ...
Description
The steering lock relay ON signal is transmitted to IPDM E/R by BCM via CAN
communication.
IPDM E/R turns the steering lock relay ON and transmits the release of the
steering to B ...
Other materials: Manual anti-glare rearview mirror
(if so equipped)
Use the night position 1 to reduce glare
from the headlights of vehicles behind you
at night.
Use the day position 2 when driving in
daylight hours.
WARNING
Use the night position only when necessary,
because it reduces rear view
clarity.
Automatic anti-glare rearview mirror
(if so equipped)
The ...
Parking/parking on hills
WARNING
Do not stop or park the vehicle over
flammable materials such as dry
grass, waste paper or rags. They may
ignite and cause a fire.
Safe parking procedures require that
both the parking brake beset and the
transmission placed into P (Park).
Failure to do so could cause the vehicle
...
How to park with predicted course
lines
WARNING
If the tires are replaced with different
sized tires, the predicted course lines
may be displayed incorrectly.
On a snow-covered or slippery road,
there may be a difference between
the predicted course line and the actual
course line.
If the battery is disconnected or becomes
disch ...