Nissan Altima (L32) 2007-2012 Service Manual: B210b starter control relay
Description
Starter control relay, integrated in IPDM E/R, permits the starter relay operation when in N or P position and the steering is locked or unlocked. It is installed in parallel with the starter relay.
DTC Logic
DTC DETECTION LOGIC
NOTE: • If DTC B210B is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-36, "DTC Logic".
• If DTC B210B is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to SEC-37, "DTC Logic".
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn the power supply position to start under the following conditions and wait for at least 1 second.
- CVT selector lever is in the P or N position.
- Depress the brake pedal
2. Check “Self diagnostic result” with CONSULT-III.
Is DTC detected? YES >> Refer to SEC-48, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.INSPECTION START
1. Turn ignition switch ON.
2. Check “Self diagnostic result” with CONSULT-III.
3. Touch “ERASE”.
4. Perform DTC Confirmation Procedure.
See PCS-45, "DTC Index".
Is the DTC B210B displayed again? YES >> Replace IPDM E/R. Refer PCS-48, "Removal and Installation".
NO >> Inspection End.
B210a steering lock condition switch
Description There are 2 switches in the steering unit. IPDM E/R compares those 2 switches conditions to judge the present steering status and transmit the result to BCM via CAN communication. DTC ...B210c starter control relay
Description Starter control relay, integrated in IPDM E/R, permits the starter relay operation when in N or P position and the steering is locked or unlocked. It is installed in parallel with the ...Other materials:
P0075 IVT control solenoid valve
Description
Intake valve timing control solenoid valve is activated by ON/OFF
pulse duty (ratio) signals from the ECM.
The intake valve timing control solenoid valve changes the oil
amount and direction of flow through intake valve timing control unit
or stops oil flow.
The longer pulse wi ...
Shift lock system
Description
The selector lever cannot be shifted from “P” position to any other position
unless the ignition switch is in the
ON position and the brake pedal is depressed.
Wiring Diagram - CVT SHIFT LOCK SYSTEM -
Coupe
Wiring Diagram - CVT SHIFT LOCK SYSTEM -
Sedan
Diagnosi ...
Front power seat adjustment (if so equipped for driver’s seat)
Operating tips
WARNING
Before driving the vehicle, return the seatback
to an upright seating position after
manually releasing it. Also, make sure the
seat is locked in place. Failure to do so
may cause the seat to move in a collision
or sudden stop. This may result in damage
to the seat o ...