Nissan Altima 2007-2012 Service Manual: B210C starter control relay
Description
Starter control relay, integrated in IPDM E/R, permits the starter relay operation when in N or P position and the steering is locked or unlocked. It is installed in parallel with the starter relay.
DTC Logic
DTC DETECTION LOGIC
NOTE: • If DTC B210C is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-235, "DTC Logic".
• If DTC B210C is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to SEC-236, "DTC Logic".
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn the power supply position to start under the following conditions and wait for at least 1 second.
- CVT selector lever is in the P or N position.
- Depress the brake pedal
2. Check “Self diagnostic result” with CONSULT-III.
Is DTC detected? YES >> Refer to SEC-248, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.INSPECTION START
1. Turn ignition switch ON.
2. Check “Self diagnostic result” with CONSULT-III.
3. Touch “ERASE”.
4. Perform DTC Confirmation Procedure.
Refer to PCS-45, "DTC Index".
Is the DTC B210C displayed again? YES >> Replace IPDM E/R. Refer to PCS-48, "Removal and Installation".
NO >> Inspection End.
B210b starter control relay
Description Starter control relay, integrated in IPDM E/R, permits the starter relay operation when in N or P position and the steering is locked or unlocked. It is installed in parallel with the ...B210D starter relay
Description Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal ...Other materials:
Diagnosis and repair work flow
Work Flow
OVERALL SEQUENCE
*1 SRC-12, "Trouble Diagnosis Introduction"
Introduction"
*2 SRC-12, "SRS Operation Check"
*3 SRC-5, "Trouble Diagnosis with
CONSULT-III"
*4 SRC-14, "Self-Diagnosis Function
(Without CONSULT-III)"
DETAILED WORK FLOW
...
Low tire pressure warning lamp
blinks
Low Tire Pressure Warning Lamp Flashes When
Ignition Switch Is Turned On
NOTE:
If low tire pressure warning lamp flashes as shown, the system is normal.
Flash Mode A
• This mode shows transmitter status is OFF-mode.
Carry out transmitter wake up operation. Refer to WT-5, "Transmitter
...
Precaution
Supplemental Restraint System (SRS) "AIR BAG"
and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
driver and front ...