Nissan Altima 2007-2012 Service Manual: B2191, P1615 difference of key

Description

Performs ID verification through BCM and Intelligent Key when push-button ignition switch is pressed.

Prohibits the release of steering lock or start of engine when an unregistered ID of Intelligent Key is used.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Press the push-button ignition switch.

2. Check “Self Diagnostic Result” with CONSULT-III.

Is DTC detected? YES >> Refer to SEC-266, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.PERFORM INITIALIZATION

Perform initialization with CONSULT-III. Re-register all Intelligent Keys.

For initialization and registration of Intelligent Key, refer to “CONSULT-III Operation Manual.

Can the system be initialized and can the engine be started with re-registered Intelligent Key? YES >> ID was unregistered.

NO >> BCM is malfunctioning.

• Replace BCM. Refer to BCS-96, "Removal and Installation".

• Perform initialization again.

• Replace ECM.

     B2190, P1610 nats antenna AMP
    Description Performs ID verification through BCM and Intelligent Key when push-button ignition switch is pressed. Prohibits the release of steering lock or start of engine when an unregistered ...

    B2192, P1611 ID discord, IMMU-ECM
    Description BCM performs the ID verification with ECM that allows the engine to start. Start the engine if the ID is OK. ECM prevents the engine from starting if the ID is not registered. BCM st ...

    Other materials:

    Satellite radio antenna
    Removal and Installation REMOVAL 1. Lower the headliner at the rear. Refer to INT-20, "Removal and Installation" (coupe) and INT-42, "Removal and Installation" (sedan). 2. Remove the satellite radio antenna nut (A), then disconnect the satellite radio antenna connector ...

    P0603 ECM Power supply
    Description Battery voltage is supplied to the ECM even when the ignition switch is turned OFF for the ECM memory function of the DTC memory, the air-fuel ratio feedback compensation value memory, the idle air volume learning value memory, etc. DTC Logic DTC DETECTION LOGIC DTC CONFIRMAT ...

    P2118 throttle control motor
    Description The throttle control motor is operated by the ECM and it opens and closes the throttle valve. The current opening angle of the throttle valve is detected by the throttle position sensor and it provides feedback to the ECM to control the throttle control motor to make the throttl ...