Nissan Altima 2007-2012 Service Manual: B2192, P1611 ID discord, immu-ECM
Description
BCM performs the ID verification with ECM that allows the engine to start. Start the engine if the ID is OK.
ECM prevents the engine from starting if the ID is not registered. BCM starts the communication with ECM if ignition switch is turned ON.
DTC Logic
DTC DETECTION LOGIC
NOTE: • If DTC B2192 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-36, "DTC Logic".
• If DTC B2192 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to SEC-37, "DTC Logic".
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON under the following conditions.
- CVT selector lever is in the P or N position
- Do not depress the brake pedal
2. Check “Self diagnostic result” with CONSULT-III.
Is DTC detected? YES >> Refer to SEC-68, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.PERFORM INITIALIZATION
Perform initialization with CONSULT-III. Re-register all Intelligent Keys.
For initialization and registration of Intelligent Key. Refer to CONSULT-III Operation Manual.
Can the system be initialized and can the engine be started with re-registered Intelligent Key? YES >> ID was unregistered.
NO >> BCM is malfunctioning.
• Replace BCM. Refer to BCS-96, "Removal and Installation".
• Perform initialization again.
• Replace ECM.
B2191, P1615 difference of key
Description
Performs ID verification through BCM and Intelligent Key when push-button
ignition switch is pressed.
Prohibits the release of steering lock or start of engine when an unregistered ...
B2193, P1612 chain of ecm-immu
Description
BCM performs the ID verification with ECM that allows the engine to start.
Start the engine if the ID is OK.
ECM prevents the engine from starting if the ID is not registered. BCM s ...
Other materials:
P0112, p0113 iat sensor
Description
The intake air temperature sensor is built-into mass air flow sensor
(1). The sensor detects intake air temperature and transmits a signal
to the ECM.
The temperature sensing unit uses a thermistor which is sensitive to
the change in temperature. Electrical resistance of the therm ...
Front door speaker (sedan)
Description
The audio unit sends audio signals to the front door speakers using the
door speaker circuits.
Diagnosis Procedure
1.HARNESS CHECK
1. Disconnect audio unit connector M43 (A) and suspect speaker
connector (B).
2. Check continuity between audio unit harness connector M43 (A)
t ...
Electrical leak detector
Electronic Refrigerant Leak Detector
PRECAUTIONS FOR HANDLING THE LEAK DETECTOR
When performing a refrigerant leak check, use a electronic refrigerant
leak detector (J-41995) or equivalent. Ensure that the instrument
is calibrated and set properly per the manufacturer's operating
instructions.
...