Nissan Altima 2007-2012 Service Manual: B2192, P1611 ID discord, IMMU-ECM

Description

BCM performs the ID verification with ECM that allows the engine to start. Start the engine if the ID is OK.

ECM prevents the engine from starting if the ID is not registered. BCM starts the communication with ECM if ignition switch is turned ON.

DTC Logic

DTC DETECTION LOGIC

NOTE: • If DTC B2192 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-235, "DTC Logic".

• If DTC B2192 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to SEC-236, "DTC Logic".

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON under the following conditions: - CVT selector lever is in the P or N position.

- Do not depress the brake pedal.

2. Check “Self Diagnostic Result” with CONSULT-III.

Is DTC detected? YES >> Refer to SEC-267, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.PERFORM INITIALIZATION

Perform initialization with CONSULT-III. Re-register all Intelligent Keys.

For initialization and registration of Intelligent Key, refer to “CONSULT-III Operation Manual.

Can the system be initialized and can the engine be started with re-registered Intelligent Key? YES >> ID was unregistered.

NO >> BCM is malfunctioning.

• Replace BCM. Refer to BCS-96, "Removal and Installation".

• Perform initialization again.

• Replace ECM.

    B2191, P1615 difference of key
    Description Performs ID verification through BCM and Intelligent Key when push-button ignition switch is pressed. Prohibits the release of steering lock or start of engine when an unregistered ...

    B2193, P1612 chain of ECM-IMMU
    Description BCM performs the ID verification with ECM that allows the engine to start. Start the engine if the ID is OK. ECM prevents the engine from starting if the ID is not registered. BCM s ...

    Other materials:

    Accelerator pedal released position learning
    Description Accelerator Pedal Released Position Learning is a function of ECM to learn the fully released position of the accelerator pedal by monitoring the accelerator pedal position sensor output signal. It must be performed each time harness connector of accelerator pedal position sensor ...

    P0340 CMP sensor (phase)
    Description The camshaft position sensor (PHASE) senses the retraction of camshaft (INT) to identify a particular cylinder. The camshaft position sensor (PHASE) senses the piston position. When the crankshaft position sensor (POS) system becomes inoperative, the camshaft position sensor (PHAS ...

    B2560 starter control relay
    Description Starter control relay, integrated in IPDM E/R, permits the starter relay operation when in N or P position and the steering is locked or unlocked. It is installed in parallel with the starter relay. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2560 is displayed with DTC U1 ...