Nissan Altima 2007-2012 Service Manual: B2193, P1612 chain of ECM-IMMU

Description

BCM performs the ID verification with ECM that allows the engine to start. Start the engine if the ID is OK.

ECM prevents the engine from starting if the ID is not registered. BCM starts the communication with ECM if ignition switch is turned ON.

DTC Logic

DTC DETECTION LOGIC

NOTE: • If DTC B2193 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-433, "DTC Logic".

• If DTC B2193 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to SEC-434, "DTC Logic".

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON under the following conditions: - CVT selector lever is in the P or N position.

- Do not depress brake pedal.

2. Check “Self Diagnostic Result” with CONSULT-III.

Is DTC detected? YES >> Refer to SEC-460, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.REPLACE BCM

1. Replace BCM. Refer to BCS-96, "Removal and Installation".

2. Perform initialization with CONSULT-III.

For initialization, refer to “CONSULT-III Operation Manual.

Does the engine start? YES >> BCM is malfunctioning.

• Replace BCM. Refer to BCS-96, "Removal and Installation".

• Perform initialization again.

NO >> ECM is malfunctioning.

• Replace ECM.

• Perform ECM re-communicating function.

    B2192, P1611 ID discord, immu-ecm
    Description BCM performs the ID verification with ECM that allows the engine to start. Start the engine if the ID is OK. ECM prevents the engine from starting if the ID is not registered. BCM s ...

    B2555 stop lamp
    Description BCM detects the stop lamp status and confirms the stop lamp switch ON/OFF status. BCM confirms the engine start condition according to the stop lamp switch ON/OFF status. DTC Logic ...

    Other materials:

    P0037, P0038 HO2S2 Heater
    Description SYSTEM DESCRIPTION The ECM performs ON/OFF control of the heated oxygen sensor 2 heater corresponding to the engine speed, amount of intake air and engine coolant temperature. OPERATION DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC C ...

    Condenser
    Removal and Installation - Coupe REMOVAL 1. Remove the rear seat cushion and the rear seatback. Refer to SE-25, "Removal and Installation". 2. Remove the rear kicking plate, rear wheel well garnish and the rear pillar finisher. Refer to INT-19, "Removal and Installation&q ...

    Rear view monitor system (sedan)
    System Diagram System Description When the selector is in the R position, the display will show a view to the rear of the vehicle. Lines which indicate the vehicle clearance and distances are also displayed. AV COMMUNICATION LINE The rear view camera control unit is connected to the AV co ...