Nissan Altima 2007-2012 Service Manual: B2555 stop lamp

Description

BCM detects the stop lamp status and confirms the stop lamp switch ON/OFF status. BCM confirms the engine start condition according to the stop lamp switch ON/OFF status.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Depress the brake pedal and wait for at least 1 second.

2. Check “Self Diagnostic Result” with CONSULT-III.

Is DTC detected? YES >> Refer to SEC-461, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.CHECK STOP LAMP SWITCH INPUT SIGNAL

1. Turn ignition switch OFF.

2. Disconnect BCM harness connector.

3. Check voltage between BCM harness connector and ground.

Is the inspection result normal? YES >> Stop lamp switch is OK.

NO >> GO TO 2

2.CHECK STOP LAMP SWITCH POWER SUPPLY CIRCUIT

1. Disconnect stop lamp switch harness connector.

2. Check voltage between stop lamp harness connector and ground.

Is the inspection result normal? YES >> GO TO 3

NO >> Check harness for open or short between stop lamp switch and fuse.

3.CHECK STOP LAMP SWITCH CIRCUIT

1. Check continuity between stop lamp switch harness connector E38 (A) terminal 2 and BCM harness connector M18 (B) terminal 26.

2. Check continuity between stop lamp switch harness connector E38 (A) terminal 2 and ground.

Is the inspection result normal? YES >> GO TO 4

NO >> Repair harness or connector.

4.CHECK STOP LAMP SWITCH

Refer to SEC-462, "Component Inspection".

Is the inspection result normal? YES >> GO TO 5

NO >> Replace stop lamp switch.

5.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> Inspection End.

Component Inspection

1.CHECK STOP LAMP SWITCH

1. Turn ignition switch OFF.

2. Disconnect stop lamp switch harness connector.

3. Check continuity between stop lamp switch terminals under the following conditions.

Is the inspection result normal? YES >> Inspection End.

NO >> Replace stop lamp switch.

    B2193, P1612 chain of ECM-IMMU
    Description BCM performs the ID verification with ECM that allows the engine to start. Start the engine if the ID is OK. ECM prevents the engine from starting if the ID is not registered. BCM s ...

    B2556 push-button ignition switch
    Description The switch that changes the power supply position. BCM maintains the power supply position status. BCM changes the power supply position with the operation of the push-button ignition ...

    Other materials:

    On-vehicle repair
    ACCELERATOR CONTROL SYSTEM Exploded View 1. Accelerator pedal and accelerator position sensor assembly. 2. Locating pins Removal and Installation REMOVAL 1. Disconnect the battery negative terminal. 2. Disconnect the accelerator position sensor electrical connector. 3. Remove the t ...

    Vehicle information display warnings and indicators
    1. No Key Detected 2. Key ID Incorrect 3. Shift to Park 4. Push ignition to OFF 5. Key Battery Low 6. Engine start operation for Intelligent Key system 7. Release parking brake 8. Low Fuel 9. Low Washer Fluid 10. Door Open 11. Trunk Open 12. Timer Alert – Time for a driver break? 13 ...

    P0117, P0118 ECT sensor
    Description The engine coolant temperature sensor is used to detect the engine coolant temperature. The sensor modifies a voltage signal from the ECM. The modified signal returns to the ECM as the engine coolant temperature input. The sensor uses a thermistor which is sensitive to the change i ...