Nissan Altima 2007-2012 Service Manual: B2556 push-button ignition switch

Description

The switch that changes the power supply position. BCM maintains the power supply position status. BCM changes the power supply position with the operation of the push-button ignition switch.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Start the engine and wait for at least 100 seconds.

2. Check “Self Diagnostic Result” with CONSULT-III.

Is DTC detected? YES >> Refer to SEC-271, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.CHECK PUSH-BUTTON IGNITION SWITCH INPUT SIGNAL

1. Turn ignition switch OFF.

2. Disconnect push-button ignition switch harness connector.

3. Check voltage between push-button ignition switch harness connector and ground.

Is the inspection result normal? YES >> GO TO 2

NO >> GO TO 4

2.CHECK PUSH-BUTTON IGNITION SWITCH

Refer to SEC-272, "Component Inspection".

Is the inspection result normal? YES >> GO TO 3

NO >> Replace push-button ignition switch. Refer to SEC-410, "Removal and Installation".

3.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> Inspection End.

4.CHECK PUSH-BUTTON IGNITION SWITCH CIRCUIT FOR SHORT

1. Disconnect BCM harness connector and IPDM E/R harness connector.

2. Check continuity between push-button ignition switch harness connector and ground.

Is the inspection result normal? YES >> Replace BCM. Refer to BCS-96, "Removal and Installation".

NO >> Repair harness or connector.

Component Inspection

1.CHECK PUSH-BUTTON IGNITION SWITCH

1. Turn ignition switch OFF.

2. Disconnect push-button ignition switch harness connector.

3. Check continuity between push-button ignition switch terminals under the following conditions.

Is the inspection result normal? YES >> Inspection End.

NO >> Replace push-button ignition switch. Refer to SEC-410, "Removal and Installation".

    B2555 stop lamp
    Description BCM detects the stop lamp status and confirms the stop lamp switch ON/OFF status. BCM confirms the engine start condition according to the stop lamp switch ON/OFF status. DTC Logic ...

    B2557 vehicle speed
    Description BCM receives the 2 vehicle speed signals via CAN communication. One signal is transmitted by the “unified meter”. Another signal is transmitted by “ABS actuator and electric uni ...

    Other materials:

    Driver air bag module
    Exploded View 1. Steering switch connector 2. Steering switch ground connector 3. Steering switches 4. Driver air bag module 5. Driver air bag module connectors 6. Side lid (RH/LH) A. Steering switch screw B. Driver air bag module bolt (RH/LH) Removal and Installation REMOVAL CAUTION: ...

    CD changer
    Diagnosis Procedure 1.CHECK FUSE Check that the following fuses of the CD changer are not blown. Are the fuses OK? YES >> GO TO 2 NO >> Be sure to eliminate cause of malfunction before installing new fuse. 2.CHECK POWER SUPPLY CIRCUIT Check voltage between CD changer harness con ...

    Mechanical system
    Cross-Sectional View 1. Converter housing 2. Oil pump 3. Forward clutch 4. Reverse brake 5. Planetary carrier 6. Primary pulley 7. Steel belt 8. Sun gear 9. Side cover 10. Internal gear 11. Secondary pulley 12. Final gear 13. Differential case 14. Idler gear 15. Reduction gear 16. ...