Nissan Altima 2007-2012 Service Manual: B2560 starter control relay

Description

Starter control relay, integrated in IPDM E/R, permits the starter relay operation when in N or P position and the steering is locked or unlocked. It is installed in parallel with the starter relay.

DTC Logic

DTC DETECTION LOGIC

NOTE: • If DTC B2560 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-36, "DTC Logic".

• If DTC B2560 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to SEC-37, "DTC Logic".

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON under the following conditions and wait for at least 2 seconds.

- CVT selector lever is in the P position

- Depress the brake pedal

2. Check “Self diagnostic result” with CONSULT-III.

Is DTC detected? YES >> Refer to SEC-75, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.CHECK DTC WITH IPDM E/R

Check “Self diagnostic result” with CONSULT-III. Refer to PCS-45, "DTC Index".

Is the inspection result normal? YES >> GO TO 2

NO >> Repair or replace malfunctioning parts.

2.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> Inspection End.

    B2557 vehicle speed
    Description BCM receives the 2 vehicle speed signals via CAN communication. 1 signal is transmitted by the “unified meter” Another signal is transmitted by “ABS actuator and electric unit ( ...

    B2601 shift position
    Description BCM confirms the shift position with the following 2 signals. • CVT selector lever • P position signal from IPDM E/R (CAN) DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B260 ...

    Other materials:

    B2619 BCM
    Description BCM requests IPDM E/R to supply power to steering lock unit. After receiving the power, the steering lock unit transmits an ON signal to BCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Press the push-button ignition switc ...

    U0415 vehicle speed sig
    Description U0415 is displayed if any unusual condition is present in the reception status of the vehicle speed signal from the ABS actuator and electric unit (control unit). DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1. DTC CONFIRMATION 1. Erase the DTC. 2. Turn igniti ...

    Inside mirror
    Exploded View 1. Inside mirror 2. Inside mirror finisher (if equipped) 3. Mirror base Removal and Installation 1. Remove inside mirror finisher (if equipped). 2. Remove screw of mirror base. 3. Slide the mirror upward to remove. 4. Disconnect the connector (if equipped). INSTALL ...