Nissan Altima (L32) 2007-2012 Service Manual ≻ Body control system bcm ≻ Component diagnosis ≻ B2562 low voltage

Nissan Altima (L32) 2007-2012 Service Manual: B2562 low voltage

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1. DTC CONFIRMATION

1. Erase DTC.

2. Turn ignition switch OFF.

3. Perform the "SELF-DIAG RESULTS" of CONSULT-III, after the ignition switch has been turned ON for 1.5 seconds or more.

Is any DTC detected? YES >> Refer to BCS-41, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1. CHECK BATTERY VOLTAGE

Check battery voltage.

Is battery voltage less than 8.8V? Yes >> Charge battery and retest. Refer to PG-72, "Work Flow".

No >> GO TO 2

2. CHECK POWER SUPPLY CIRCUIT

Check BCM power supply circuit. Refer to BCS-42, "Diagnosis Procedure".

Is the circuit OK? Yes >> Replace BCM. Refer to BCS-96, "Removal and Installation".

No >> Repair or replace the malfunctioning part.

Special Repair Requirement

1. REQUIRED WORK WHEN REPLACING BCM

Initialize control unit. Refer to BCS-6, "CONFIGURATION (BCM) : Special Repair Requirement".

>> Work End.

U0415 vehicle speed sig

Description U0415 is displayed if any unusual condition is present in the reception status of the vehicle speed signal from the ABS actuator and electric unit (control unit). DTC Logic DTC DET ...

Power supply and ground circuit

Diagnosis Procedure 1. CHECK FUSE AND FUSIBLE LINK Check if the following BCM fuse or fusible link are blown. Is the fuse or fusible link blown? YES >> Replace the blown fuse or fusible li ...

Other materials:

Car phone or CB radio
When installing a CB, ham radio or car phone in your vehicle, be sure to observe the following precautions; otherwise, the new equipment may adversely affect the engine control system and other electronic parts. WARNING A cellular phone should not be used for any purpose while driving so full at ...

RCTA system operation
For vehicles with the 7 inch (18 cm) display Side BSW/RCTA Indicator Light The RCTA system can help alert the driver of an approaching vehicle when the driver is backing out of a parking space. For vehicles with the 5 inch (13 cm) display When the shift position is in R (Reverse) and the vehicl ...

Changing a flat tire
If you have a flat tire, follow the instructions below: Stopping the vehicle 1. Safely move the vehicle off the road and away from traffic. 2. Turn on the hazard warning flashers. 3. Park on a level surface and apply the parking brake. Move the shift lever to P (Park). 4. Turn off the engine. 5. ...