Nissan Altima 2007-2012 Service Manual: B2606 steering lock relay

Description

The steering lock relay ON signal is transmitted to IPDM E/R by BCM via CAN communication.

IPDM E/R turns the steering lock relay ON and transmits the release of the steering to BCM.

DTC Logic

DTC DETECTION LOGIC

NOTE: • If DTC B2606 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-36, "DTC Logic".

• If DTC B2606 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to SEC-37, "DTC Logic".

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Press the push-button ignition switch under the following conditions.

- CVT selector lever is in the P or N position.

- Do not depress the brake pedal.

2. Steering is locked.

3. Check “Self diagnostic result” with CONSULT-III.

Is DTC detected? YES >> Refer to SEC-88, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.CHECK DTC WITH IPDM E/R

Check “Self diagnostic result” with CONSULT-III. Refer to PCS-45, "DTC Index".

Is the inspection result normal? YES >> GO TO 2

NO >> Repair or replace malfunctioning parts.

2.INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> Inspection End.

    B2605 PNP switch
    Description BCM confirms the shift position with the following 4 signals. • AT selector lever • P/N position switch • P position signal from IPDM E/R (CAN) • P position signal from TCM ...

    B2607 steering lock relay
    Description BCM requests to IPDM E/R to supply power to electronic steering column lock. IPDM E/R sends status of steering lock unit back to BCM. DTC Logic DTC DETECTION LOGIC NOTE: • If D ...

    Other materials:

    P0850 PNP Switch
    Description When the shift lever position is P or N (CVT), Neutral position (M/T), park/neutral position (PNP) switch is ON. ECM detects the position because the continuity of the line (the ON signal) exists. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.INSPECTION START ...

    Bluetooth® Hands-Free Phone System with Navigation System (if so equipped)
    WARNING ● Use a phone after stopping your vehicle in a safe location. If you have to use a phone while driving, exercise extreme caution at all times so full attention may be given to vehicle operation. ● If you are unable to devote full attention to vehicle operation while talkin ...

    Programming HomeLink®
    If you have any questions or are having difficulty programming your HomeLink® buttons, refer to the HomeLink® web site at: www.homelink.com or call 1-800-355-3515. NOTE: Place the ignition switch in the ACC position when programming HomeLink®. It is also recommended that a new battery be ...