Nissan Altima (L32) 2007-2012 Service Manual: B2606 steering lock relay
Description
The steering lock relay ON signal is transmitted to IPDM E/R by BCM via CAN
communication.
IPDM E/R turns the steering lock relay ON and transmits the release of the
steering to BCM.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2606 is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to
SEC-433, "DTC Logic".
• If DTC B2606 is displayed with DTC U1010, first perform the trouble diagnosis
for DTC U1010. Refer to
SEC-434, "DTC Logic".
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Press the push-button ignition switch under the following conditions.
- CVT selector lever is in the P or N position.
- Do not depress the brake pedal.
2. Steering is locked.
3. Check “Self diagnostic result” with CONSULT-III.
Is DTC detected?
YES >> Refer to SEC-479, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.CHECK DTC WITH IPDM E/R
Check “Self diagnostic result” with CONSULT-III. Refer to PCS-45, "DTC
Index".
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace malfunctioning parts.
2.INTERMITTENT INCIDENT
Refer to GI-42, "Intermittent Incident".
>> Inspection End.
Description
BCM confirms the shift position with the following 4 signals.
• CVT selector lever
• P/N position switch
• P position signal from IPDM E/R (CAN)
• P position signal from TC ...
Description
BCM requests to IPDM E/R to supply power to electronic steering column lock.
IPDM E/R sends status of
electronic steering column lock back to BCM.
DTC Logic
DTC DETECTION LOGIC
NOT ...
Other materials: Turning the RAB system on/off
For vehicles with the 7 inch (18 cm) display
Perform the following steps to turn the RAB
system ON or OFF.
For vehicles with the 7 inch (18 cm) display.
1. Press thebutton until
"Settings" displays
in the vehicle information display.
Use thebutton to select "Driver
Assistance."
Then press the OK ...
System operation
The system informs with a visual and audible
alert of rear obstacles when the shift
lever is in the R (Reverse) position.
The system is deactivated at speeds above
6 mph (10 km/h). It is reactivated at lower
speeds.
The intermittent tone will stop after 3 seconds
when an obstacle is detected by on ...
Sun visors
To block glare from the front, swing
down the main sun visor 1.
To block glare from the side, remove the
main sun visor 2 from the center
mount and swing the visor to the side.
To extend the sun visor, slide in or out as
needed 3.
CAUTION
Do not store the sun visor before returning ...