Nissan Altima (L32) 2007-2012 Service Manual ≻ Security control system coupe ≻ Component diagnosis ≻ B260b steering lock unit

Nissan Altima (L32) 2007-2012 Service Manual: B260b steering lock unit

Description

The steering lock unit performs the check by itself according to the steering status.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Press the push-button ignition switch, when steering is locked.

2. Check “Self diagnostic result” with CONSULT-III.

Is DTC detected? YES >> Refer to SEC-97, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.INSPECTION START

1. Turn ignition switch ON.

2. Check “Self diagnostic result” with CONSULT-III.

3. Touch “ERASE”.

4. Perform DTC Confirmation Procedure.

See SEC-97, "DTC Logic".

Is the DTC B260B displayed again? YES >> Replace electronic steering column lock.

NO >> Inspection End.

B2609 steering status

Description There are 2 switches in the electronic steering column lock (steering lock/unlock switch 1 and 2). BCM compares those two switches conditions to judge the present steering status. DT ...

B260c steering lock unit

Description The electronic steering column lock performs the check by itself according to the steering status. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRM ...

Other materials:

MOD system operation
The MOD system will turn on automatically under the following conditions: When the shift lever is in the R (Reverse) position. When the CAMERA button is pressed to activate the camera view on the display. When vehicle speed decreases below approximately 6 mph (10 km/h) and the camera screen ...

Windshield wiper blades
Cleaning If your windshield is not clear after using the windshield-washer or if a wiper blade chatters when running, wax or other material may be on the blade or windshield. Clean the outside of the windshield with a washer fluid or a mild detergent. Your windshield is clean if beads do not form w ...

Front power seat adjustment (if so equipped)
Operating tips The power seat motor has an auto-reset overload protection circuit. If the motor stops during operation, wait 30 seconds then reactivate the switch. Do not operate the power seat switch for a long period of time when the engine is off. This will discharge the battery. For add ...