Nissan Altima (L32) 2007-2012 Service Manual: B260B steering lock unit
Description
The electronic steering column lock performs the check by itself according to the steering status.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Press the push-button ignition switch, when steering is locked.
2. Check “Self diagnostic result” with CONSULT-III.
Is DTC detected? YES >> Refer to SEC-488, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.INSPECTION START
1. Turn ignition switch ON.
2. Check “Self diagnostic result” with CONSULT-III.
3. Touch “ERASE”.
4. Perform DTC Confirmation Procedure.
See SEC-488, "DTC Logic".
Is the DTC B260B displayed again? YES >> Replace electronic steering column lock.
NO >> Inspection End.
B2609 steering status
Description There are 2 switches in the electronic steering column lock (steering lock/unlock switch 1 and 2). BCM compares those two switches conditions to judge the present steering status. DT ...B260C steering lock unit
Description The electronic steering column lock performs the check by itself according to the steering status. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRM ...Other materials:
Bose speaker AMP
Diagnosis Procedure
1.CHECK FUSE
Check for blown fuses.
Are the fuses OK?
YES >> GO TO 2
NO >> Be sure to eliminate cause of malfunction before installing new fuse.
2.CHECK POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect BOSE speaker amp connector.
3. Chec ...
IPDM-E branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the IPDM E/R for damage, bend and loose
connection (unit side
and connector side).
Is the in ...
Blower unit
Removal and Installation
COMPONENTS
1. Heater and cooling unit
2. Blower unit
Front
REMOVAL
1. Remove the heater and cooling unit assembly. Refer to VTL-12, "Removal and
Installation".
2. Disconnect the blower motor connector.
3. Remove the screws from the blower unit, the ...