Nissan Altima 2007-2012 Service Manual: B260D steering lock unit

Description

The electronic steering column lock performs the check by itself according to the steering lock status (before lock, after lock and unlock).

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.

2. Turn ignition switch OFF.

3. Press door switch.

4. Check “Self diagnostic result” with CONSULT-III.

Is DTC detected? YES >> Refer to SEC-298, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.INSPECTION START

1. Turn ignition switch ON.

2. Check “Self diagnostic result” with CONSULT-III.

3. Touch “ERASE”.

4. Perform DTC Confirmation Procedure.

See SEC-298, "DTC Logic".

Is the DTC B260D displayed again? YES >> Replace electronic steering column lock.

NO >> Inspection End.

    B260C steering lock unit
    Description The electronic steering column lock performs the check by itself according to the steering status. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMA ...

    B260F engine status
    Description BCM receives the engine status signal from ECM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B260F is displayed with DTC U1000, first perform the trouble dia ...

    Other materials:

    P0132, P0152 A/F sensor 1
    Description The air fuel ratio (A/F) sensor 1 is a planar one-cell limit current sensor. The sensor element of the A/F sensor 1 is composed an electrode layer, which transports ions. It has a heater in the element. The sensor is capable of precise measurement = 1, but also in the lean and ...

    B260C steering lock unit
    Description The electronic steering column lock performs the check by itself according to the steering status. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Turn ignition switch OFF. 3. Press door switch ...

    Differential side oil seal
    Exploded View 1. Transaxle assembly 2. Differential side oil seal Removal and Installation REMOVAL 1. Remove drive shaft assembly. Refer to FAX-11, "Removal and Installation (Left Side)" and FAX-12, "Removal and Installation (Right Side)". 2. Remove the differential ...