Nissan Altima (L32) 2007-2012 Service Manual: B260f engine status
Description
BCM receives the engine status signal from ECM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B260F is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to
SEC-36, "DTC Logic".
• If DTC B260F is displayed with DTC U1010, first perform the trouble diagnosis
for DTC U1010. Refer to
SEC-37, "DTC Logic".
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON under the following conditions.
- CVT selector lever is in the P position.
- Do not depress the brake pedal.
2. Check “Self diagnostic result” with CONSULT-III.
Is DTC detected?
YES >> Refer to SEC-100, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.INSPECTION START
1. Turn ignition switch ON.
2. Check “Self diagnostic result” with CONSULT-III.
3. Touch “ERASE”.
4. Perform DTC Confirmation Procedure.
See SEC-100, "DTC Logic".
Is the DTC B260F displayed again?
YES >> GO TO 2
NO >> Inspection End.
2.REPLACE ECM
1. Replace ECM.
2. Refer to EC-1048, "BASIC INSPECTION : Special Repair Requirement" (VQ35DE),
EC-24, "BASIC
INSPECTION : Special Repair Requirement" (QR25DE California) or EC-560, "BASIC
INSPECTION :
Special Repair Requirement" (QR25DE except for California).
>> Inspection End.
Description
The electronic steering column lock performs the check by itself according to
the steering lock status (before
lock, after lock and unlock).
DTC Logic
DTC DETECTION LOGIC
DTC CO ...
Description
There are 2 switches in the steering unit. IPDM E/R compares those 2 switches
conditions to judge the
present steering status and transmit the result to BCM via CAN communication.
DT ...
Other materials: Control panel buttons
Display screen
TUNE-SCROLL knob / PUSH SOUND
button
BACK button
DISP button
button*
MENU button
(brightness control)
button
VOL (volume) knob / PUSH
(power)
button
* For additional information regarding the
Bluetooth Hands-Free Phone System
control button, see "Bluetooth Hands-
...
Forward-facing child restraint
installation using the seat belts
WARNING
The three-point seat belt with Automatic
Locking Retractor (ALR) must be
used when installing a child restraint.
Failure to use the ALR mode will result
in the child restraint not being properly
secured. The restraint could tip over or
be loose and cause injury to a child in a
sudden stop o ...
Additional maintenance items for
severe operating conditions
Additional maintenance items for severe
operating conditions should be performed
on vehicles that are driven under
especially demanding conditions. Additional
maintenance items should be performed
if you primarily operate your vehicle
under the following conditions:
Repeated short trips of less th ...