Nissan Altima 2007-2012 Service Manual: B260F engine status

Description

BCM receives the engine status signal from ECM via CAN communication.

DTC Logic

DTC DETECTION LOGIC

NOTE: • If DTC B260F is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-433, "DTC Logic".

• If DTC B260F is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to SEC-434, "DTC Logic".

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON under the following conditions.

- CVT selector lever is in the P position.

- Do not depress the brake pedal.

2. Check “Self diagnostic result” with CONSULT-III.

Is DTC detected? YES >> Refer to SEC-491, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.INSPECTION START

1. Turn ignition switch ON.

2. Check “Self diagnostic result” with CONSULT-III.

3. Touch “ERASE”.

4. Perform DTC Confirmation Procedure.

See SEC-491, "DTC Logic".

Is the DTC B260F displayed again? YES >> GO TO 2

NO >> Inspection End.

2.REPLACE ECM

1. Replace ECM.

2. Refer to EC-560, "BASIC INSPECTION : Special Repair Requirement" (QR25DE except California) or EC-24, "BASIC INSPECTION : Special Repair Requirement" (QR25DE California).

>> Inspection End.

    B260D steering lock unit
    Description The electronic steering column lock performs the check by itself according to the steering lock status (before lock, after lock and unlock). DTC Logic DTC DETECTION LOGIC DTC CON ...

    B2612 steering status
    Description There are 2 switches in the electronic steering column lock. IPDM E/R compares those 2 switches conditions to judge the present steering status and transmit the result to BCM via CAN ...

    Other materials:

    Air breather hose
    Exploded View 1. Air breather hose 2. Clip 3. Bracket 4. Air breather tube 5. CVT assembly A. Paint mark Removal and Installation Refer to the figure for removal and installation. CAUTION: • Install air breather hose with paint mark facing upward. • Insert air breather hose a m ...

    Audio system (coupe)
    System Diagram System Description AUDIO SYSTEM The audio system consists of the following components • Audio unit • BOSE speaker amp. • Window antenna • Steering wheel audio control switches • Door speakers • Front tweeters • Center speaker • Rear tweeters • Rear sub ...

    M&A branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the combination meter for damage, bend and loose connection (unit side and connector side). ...