Nissan Altima 2007-2012 Service Manual: B2614 ACC relay circuit

Description

BCM controls the various electrical components and simultaneously supplies power according to the power supply position.

BCM checks the power supply position internally.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1. PERFORM DTC CONFIRMATION PROCEDURE

1. Turn the power supply position to ACC under the following conditions, and wait for at least 1 second.

- CVT selector lever is in the P or N position.

- Release the brake pedal.

2. Check “Self diagnostic result” with CONSULT-III.

Is DTC detected? YES >> Go to PCS-65, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1. CHECK ACCESSORY RELAY POWER SUPPLY

1. Turn ignition switch OFF.

2. Disconnect accessory relay.

3. Check voltage between accessory relay harness connector and ground under the following conditions.

Is the inspection result normal? YES >> GO TO 3

NO >> GO TO 2

2. CHECK ACCESSORY RELAY POWER SUPPLY CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect BCM harness connector.

3. Check continuity between accessory relay harness connector (A) and BCM harness connector (B).

4. Check continuity between accessory relay harness connector and ground.

Is the inspection result normal? YES >> GO TO 6

NO >> Repair or replace harness.

3. CHECK ACCESSORY RELAY GROUND CIRCUIT

1. Turn ignition switch OFF.

2. Check continuity between accessory relay harness connector and ground.

Is the inspection result normal? YES >> GO TO 4

NO >> Repair or replace harness.

4. CHECK ACCESSORY RELAY POWER SUPPLY CIRCUIT-2

Check voltage between accessory relay harness connector and ground.

Is the inspection result normal? YES >> GO TO 5

NO >> Repair or replace harness.

5. CHECK ACCESSORY RELAY

Refer to PCS-67, "Component Inspection (Accessory Relay)".

YES or NO

YES >> GO TO 6

NO >> Replace accessory relay.

6. CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> Inspection End.

Component Inspection (Accessory Relay)

1. CHECK ACCESSORY RELAY

1. Turn ignition switch OFF.

2. Remove accessory relay.

3. Check the continuity between accessory relay terminals under the following conditions.

Is the inspection result normal? YES >> Inspection End.

NO >> Replace accessory relay

    B2611 ACC relay
    Description BCM turns ON the ACC relay to supply ACC power to each ECU when the power supply position changes to ACC. BCM check ACC relay ON request for consistency with the actual ACC relay ...

    B2615 blower relay circuit
    Description BCM controls the various electrical components and simultaneously supplies power according to the power supply position. BCM checks the power supply position internally. DTC Logic ...

    Other materials:

    P0452 evap control system pressure sensor
    Description The EVAP control system pressure sensor detects pressure in the purge line. The sensor output voltage to the ECM increases as pressure increases. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously condu ...

    P0130 A/F Sensor 1
    Description The air fuel ratio (A/F) sensor 1 is a planar one-cell limit current sensor. The sensor element of the A/F sensor 1 is composed an electrode layer, which transports ions. It has a heater in the element. The sensor is capable of precise measurement = 1, but also in the lean and ...

    If your vehicle overheats
    If your vehicle is overheating (indicated by an extremely high temperature gauge reading), or if you feel a lack of engine power, detect abnormal noise, etc. take the following steps. WARNING ● Do not continue to drive if your vehicle overheats. Doing so could cause engine damage or a v ...