Nissan Altima 2007-2012 Service Manual: B2615 blower relay circuit

Description

BCM controls the various electrical components and simultaneously supplies power according to the power supply position.

BCM checks the power supply position internally.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1. PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON under the following conditions, and wait for at least 1 second.

- CVT selector lever is in the P or N position.

- Release brake pedal.

2. Check “Self diagnostic result” with CONSULT-III.

Is DTC detected? YES >> Go to PCS-68, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1. CHECK BLOWER RELAY POWER SUPPLY

1. Turn ignition switch OFF.

2. Disconnect blower relay.

3. Check voltage between blower relay harness connector and ground under the following conditions.

Is the inspection result normal? YES >> GO TO 3

NO >> GO TO 2

2. CHECK BLOWER RELAY POWER SUPPLY CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect BCM harness connector.

3. Check continuity between blower relay harness connector (A) and BCM harness connector (B).

4. Check continuity between blower relay harness connector (A) and ground.

Is the inspection result normal? YES >> GO TO 6

NO >> Repair or replace harness.

3. CHECK BLOWER RELAY GROUND CIRCUIT

1. Turn ignition switch OFF.

2. Check continuity between blower relay harness connector and ground.

Is the inspection result normal? YES >> GO TO 4

NO >> Repair blower relay ground circuit.

4.CHECK BLOWER RELAY POWER SUPPLY CIRCUIT-2

Check voltage between blower relay harness connector and ground.

Is the inspection result normal? YES >> GO TO 5

NO >> Repair or replace harness.

5. CHECK BLOWER RELAY

Refer to PCS-70, "Component Inspection (Blower Relay)".

Is the inspection result normal? YES >> GO TO 6

NO >> Replace blower relay.

6. CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> Inspection End.

Component Inspection (Blower Relay)

1. CHECK BLOWER RELAY

1. Turn ignition switch OFF.

2. Remove blower relay.

3. Check the continuity between blower relay terminals under the following conditions.

Is the inspection result normal? YES >> Inspection End.

NO >> Replace blower relay.

    B2614 ACC relay circuit
    Description BCM controls the various electrical components and simultaneously supplies power according to the power supply position. BCM checks the power supply position internally. DTC Logic ...

    B2616 ignition relay circuit
    Description BCM controls the various electrical components and simultaneously supplies power according to the power supply position. BCM checks the power supply position internally. DTC Logic ...

    Other materials:

    B2607 steering lock relay
    Description BCM requests to IPDM E/R to supply power to electronic steering column lock. IPDM E/R sends status of electronic steering column lock back to BCM. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2607 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U100 ...

    Can communication circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CONNECTOR INSPECTION 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect all the unit connectors on CAN communication system. 4. Check terminals and connectors for damage, bend and loose con ...

    BSW driving situations
    Another vehicle approaching from behind The Blind spot indicator light illuminates if a vehicle enters the detection zone from behind in an adjacent lane. However, if the overtaking vehicle is traveling much faster than your vehicle, the indicator light may not illuminate before the detec ...