Nissan Altima 2007-2012 Service Manual: B2617 Starter relay circuit

Description

Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication.

DTC Logic

DTC DETECTION LOGIC

NOTE: • If DTC B2617 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-235, "DTC Logic".

• If DTC B2617 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to SEC-236, "DTC Logic".

• If DTC B2617 is displayed with DTC B210E, first perform the trouble diagnosis for DTC B210E. Refer to SEC-304, "DTC Logic".

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON under the following conditions and wait for at least 1 second.

- CVT selector lever is in the P position.

- Do not depress the brake pedal.

2. Check “Self diagnostic result” with CONSULT-III.

Is DTC detected? YES >> Refer to SEC-304, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.CHECK STARTER RELAY

1. Turn ignition switch ON.

2. Check voltage between BCM harness connector and ground under the following condition.

Is the measurement value within the specification.

YES >> GO TO 3

NO >> GO TO 2

2.CHECK STARTER RELAY CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect BCM harness connector and IPDM E/R harness connector.

3. Check continuity between IPDM E/R harness connector and BCM harness connector.

4. Check continuity between IPDM E/R harness connector and ground.

Is the inspection result normal? YES >> Replace BCM. Refer to BCS-96, "Removal and Installation".

NO >> Repair harness or connector.

3.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> Inspection End.

    B2612 Steering status
    Description There are 2 switches in the electronic steering column lock. IPDM E/R compares those 2 switches conditions to judge the present steering status and transmit the result to BCM via CAN ...

    B2619 BCM
    Description BCM requests IPDM E/R to supply power to steering lock unit. After receiving the power, the steering lock unit transmits an ON signal to BCM. DTC Logic DTC DETECTION LOGIC DTC CON ...

    Other materials:

    Air mix door motor
    Removal and Installation AIR MIX DOOR MOTOR - LH Removal 1. Remove the instrument lower cover LH. Refer to IP-12, "Removal and Installation". 2. Remove the center console side finisher LH. Refer to IP-12, "Removal and Installation". 3. Remove the heater and cooling ...

    Battery
    ● Keep the battery surface clean and dry. Clean the battery with a solution of baking soda and water. ● Make certain the terminal connections are clean and securely tightened. ● If the vehicle is not to be used for 30 days or longer, disconnect the negative (-) battery ter ...

    Steering switch
    Description When one of the steering wheel audio control switches is pushed, the resistance in the steering switch circuit changes depending on which button is pushed. Diagnosis Procedure 1.CHECK HARNESS 1. Turn ignition switch OFF. 2. Disconnect AV control unit connector M46 and spiral ...