Nissan Altima 2007-2012 Service Manual: B26E1 No reception of engine status signal

Description

BCM receives the engine status signal from ECM via CAN communication.

DTC Logic

DTC DETECTION LOGIC

NOTE: • If DTC B26E1 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-235, "DTC Logic".

• If DTC B26E1 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to SEC-236, "DTC Logic".

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON under the following conditions.

- CVT selector lever is in the P or N position.

- Do not depress the brake pedal.

2. Check “Self diagnostic result” with CONSULT-III.

Is DTC detected? YES >> Refer to SEC-309, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.INSPECTION START

1. Turn ignition switch ON.

2. Check “Self diagnostic result” with CONSULT-III.

3. Touch “ERASE”.

4. Perform DTC Confirmation Procedure.

See SEC-309, "DTC Logic".

Is the DTC B26E1 displayed again? YES >> GO TO 2

NO >> Inspection End.

2.REPLACE ECM

1. Replace ECM.

2. Refer to EC-1048, "BASIC INSPECTION : Special Repair Requirement" (VQ35DE), EC-560, "BASIC INSPECTION : Special Repair Requirement" (QR25DE except California), EC-24, "BASIC INSPECTION : Special Repair Requirement" (QR25DE California).

>> Inspection End.

    B261A push-button ignition switch
    Description IPDM E/R transmits the push-button ignition switch status via CAN communication to BCM. BCM receives push-button ignition switch status by hardwire input. BCM compares the 2 signals ...

    POWER supply and ground circuit
    BCM Diagnosis Procedure 1. CHECK FUSE AND FUSIBLE LINK Check if the following BCM fuse or fusible link are blown. Is the fuse or fusible link blown? YES >> Replace the blown fuse or fus ...

    Other materials:

    Before starting the engine
    ● Make sure the area around the vehicle is clear. ● Check fluid levels such as engine oil, coolant, brake fluid, and windshield-washer fluid as frequently as possible, or at least whenever you refuel. ● Check that all windows and lights are clean. ● Visually inspect ti ...

    P0112, P0113 iat sensor
    Description The intake air temperature sensor is built-into mass air flow sensor (1). The sensor detects intake air temperature and transmits a signal to the ECM. The temperature sensing unit uses a thermistor which is sensitive to the change in temperature. Electrical resistance of the therm ...

    P1740 lock-up select solenoid valve
    Description • Lock-up select solenoid valve controls lock-up clutch pressure or forward clutch pressure (reverse brake pressure). • When controlling lock-up clutch, the valve is turned OFF. When controlling forward clutch, it is turned ON. DTC Logic DTC DETECTION LOGIC DTC CONFIRM ...