Nissan Altima 2007-2012 Service Manual: Back-up lamp switch

Removal and Installation

For removal and installation of back-up lamp switch, refer to TM-28, "Exploded View".

Inspection

• Check continuity.

    Side oil seal
    Removal and Installation REMOVAL 1. Remove the drive shaft. Refer to FAX-11, "Removal and Installation (Left Side)", FAX-12, "Removal and Installation (Right Side)". 2. Rem ...

    Park/neutral position switch
    Removal and Installation For removal and installation of park/neutral position switch, refer to TM-28, "Exploded View". Inspection • Check continuity. ...

    Other materials:

    Automatic operation
    Cooling and/or dehumidified heating (AUTO) This mode may be used all year round as the system automatically works to keep a constant temperature. Air flow distribution and fan speed are also controlled automatically. 1. Press the AUTO button on. The indicator on the button will illuminate. ...

    P0143 HO2S3
    Description The heated oxygen sensor 3, after HC adsorption catalyst (Under floor), monitors the oxygen level in the exhaust gas on each bank. This sensor is made of ceramic zirconia. The zirconia generates voltage from approximately 1V in richer conditions to 0V in leaner conditions. Unde ...

    Main line between dlc and abs circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side). - Harness c ...